User manual ZYXEL POE12-HP

[. . . ] the PoE12-HP injects DC power through the unused twisted-wires of a standard 8-pin CAT 5 cable. This increases flexibility in the positioning of a power over Ethernet (PoE) enabled device by eliminating the need for a nearby power source. Screw the two screws provided with your PoE12-HP into the wall 106 mm apart. Do not screw the screws all the way in to the wall; leave a small gap between the head of the screw and the wall. [. . . ] Any replacement will consist of a new or re-manufactured functionally equivalent product of equal or higher value, and will be solely at the discretion of ZyXEL. This warranty shall not apply if the product has been modified, misused, tampered with, damaged by an act of God, or subjected to abnormal working conditions. This warranty is in lieu of all other warranties, express or implied, including any implied warranty of merchantability or fitness for a particular use or purpose. ZyXEL shall in no event be held liable for indirect or consequential damages of any kind to the purchaser. You may also refer to the warranty policy for the region in which you bought the device at http://www. Do NOT use this product near water, for example, in a wet basement or near a swimming pool. Opening or removing covers can expose you to dangerous high voltage points or other risks. ONLY qualified service personnel should service or disassemble this device. Place connecting cables carefully so that no one will step on them or stumble over them. Always disconnect all cables from this device before servicing or disassembling. connect it to the right supply voltage (for example , 110V AC in North America or 230V AC in Europe). Do NOT allow anything to rest on the power adaptor or cord and do NOT place the product where anyone can walk on the power adaptor or cord. Do NOT use the device if the power adaptor or cord is damaged as it might cause electrocution. If the power adaptor or cord is damaged, remove it from the device and the power source. Do not use the device outside, and make sure all the connections are indoors. Do NOT obstruct the device ventilation slots, as insufficient airflow may harm your device. Make sure that the cable system is grounded so as to provide some protection against voltage surges. Your product is marked with this symbol, which is known as the WEEE mark. [. . . ] This device generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio/television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. [. . . ]