User manual ZYXEL P-870HW-51A V2 QUICK GUIDE

[. . . ] · Internet Explorer 6. 0 or later or Netscape Navigator 7. 0 or later, with JavaScript enabled. See the User's Guide for all configuration details including file sharing and setting up a shared printer. To read the User's Guide insert the CD that came in the box into your CD-ROM drive. [. . . ] · The WLAN/WPS light stays green when the wireless LAN is ready. It blinks when the P-870HW-51a v2 is sending/receiving data through the wireless LAN. If none of the LEDs (lights) are on, check your connections. Make sure that you have the power adaptor connected to the P-870HW-51a v2 and plugged in to an appropriate power source. Turn the P-870HW-51a v2 off, wait for a few seconds and turn it back on. If the LEDs are still off, contact your local vendor. 6 ENGLISH Testing Internet Connection After you have connected the hardware and turned on the P-870HW-51a v2, open a web browser on your computer and go to any web site (for example, www. zyxel. com) to test your Internet connection. If you are prompted for a user name and password, enter the account information as given by your Internet service provider (ISP). Initial Configuration 1. Open your browser and enter http:/ /192. 168. 1. 1 (the P-870HW-51a v2's default IP address) as the address. Click OK. If the login screen does not display, make sure you allow web browser pop-up windows, JavaScripts and Java permissions. Your computer should be also set to get an IP address automatically from a DHCP server. See the appendices in your User's Guide for more information. 7 Internet Setup When your Internet connection is setup correctly, the DSL and INTERNET lights should be green. If you cannot access the Internet and the INTERNET light is off, make sure you enter the correct information in the WAN screens. If you are using a new Internet account, contact your ISP to make sure it is active. If you are trying to access the Internet wirelessly, make sure the wireless and security settings in your wireless client are the same as the settings in the P-870HW-51a v2. Wireless Setup To create a wireless network the P-870HW-51a v2 and your wireless computer(s) must all use the same SSID (network name), channel and security settings. Enable wireless LAN, enter a name to identify your wireless network (such as "ZyXEL") in the SSID field, and select a channel which is not used by neighboring wireless devices. In this example, the P-870HW-51a v2 uses WPA2-PSK for data encryption. [. . . ] Be careful to avoid damaging pipes or cables located inside the wall when drilling holes for the screws. Leave a small gap of about 0. 5 cm between the heads of the screws and the wall. They need to hold the weight of the P-870HW-51a v2 with the connection cables. [. . . ]