User manual ZYXEL NWA-3163 QUICK GUIDE

[. . . ] See your User's Guide for information on setting up your computer's IP address. Even though you can connect to the NWA1100 wirelessly, it is recommended that you connect your computer to the ETHERNET port for initial configuration. If you cannot access the Web configurator, make sure the IP addresses and subnet masks of the NWA1100 and the computer are in the same IP address range. Enter 1234 (the default password) in the Password field and click Login. [. . . ] Enter 1234 (the default password) in the Password field and click Login. If you change the password and then forget it, you will need to reset the NWA1100. DNS Server(s): if your ISP gave you specific DNS (Domain Name System) settings, select User-Defined and enter them here. Wireless Mode: Select the wireless standard you want your network to use. If you don't configure wireless security, anyone can access your network. This is where you can enter the security settings for your wireless network. The fields you fill in differ according to the type of security you select in the Security Mode field. This example uses WPA2-PSK security, in which all wireless clients must use the same pre-shared key to join the network. Ensure that all your wireless clients support the type of security you set. If the wireless clients cannot communicate with the network, ensure that the clients and the NWA1100 are using the same wireless security settings. Make sure the screws are securely fixed to the wall and strong enough to hold the weight of the NWA1100 with the connection cables. Run the connection cables down the back of the NWA1100 as shown in the following figure. Align the holes on the back of the NWA1100 with the screws on the wall. Power over Ethernet (PoE) is the ability to provide power to your NWA1100 via an 8-pin CAT 5 Ethernet cable, eliminating the need for a nearby power source. A PoE injector (not included) is also needed to supply the Ethernet cable with power. This feature allows increased flexibility in the location of your NWA1100. In the following figure, Z is your NWA1100, A is the CAT 5 Ethernet cable, B is the PoE injector and C is the power cable. Wenn Sie eine IP-Adresse haben, wählen Sie die Option Use fixed IP address (Feste IP-Adresse verwenden) und geben Sie sie zusammen mit der SubnetzMaske und der Gateway-IPAdresse ein. Wenn Sie eine bestimmte IP-Adresse haben, wählen Sie die Option Use fixed IP address (Feste IP-Adresse verwenden) und geben Sie sie zusammen mit der Subnetz-Maske und der Gateway-IP-Adresse ein. Si tiene una dirección IP específica para usar, seleccione Use fixed IP address (Utilizar dirección IP fija) e introdúzcala junto con su máscara de subred y puerta de enlace IP. [. . . ] Wenn Sie eine bestimmte IP-Adresse haben, wählen Sie die Option Use fixed IP address (Feste IP-Adresse verwenden) und geben Sie sie zusammen mit der Subnetz-Maske und der Gateway-IP-Adresse ein. Si tiene una dirección IP específica para usar, seleccione Use fixed IP address (Utilizar dirección IP fija) e introdúzcala junto con su máscara de subred y puerta de enlace IP. Si vous avez une adresse IP spécifique à utiliser, sélectionnez Use fixed IP address (Utiliser une adresse IP fixe) et entrezla avec le masque de sous-réseau et l'adresse IP de passerelle. Se si dispone di un indirizzo IP specifico da utilizzare, selezionare Use fixed IP address (utilizza indirizzo IP fisso) e specificarlo unitamente al subnet mask e all'indirizzo IP gateway. [. . . ]