User manual ZILOG ZMOTION DETECTION MODULE EVALUATION KIT QUICK START GUIDE

[. . . ] ZMOTIONTM Detection Module Evaluation Kit Quick Start Guide QS007306-0810 Introduction This quick start guide describes how to set up and use Zilog's ZMOTIONTM Detection Module Evaluation Kit. The Kit can be used to demonstrate and evaluate the operation of the ZMOTION Detection Module in both Hardware and Serial modes. [. . . ] ESD precautions must be used when handling the ZMOTION Base Board and the ZMOTION Module. Step 2: Insert ZMOTION Detection Module into Base Board The ZMOTION Detection Module should be inserted into J4 of the Base Board ensuring pin 1 is aligned correctly (indicated by a square silkscreen on the J4 connector). Figure 2. ZMOTIONTM Detection Module Step 3: Install the AC Plug Adapter The universal power supply kit features four different plug adapters in one box and the power supply by itself in another. The power supply ships with a slide-out plate that must be removed to insert the location-specific plug adapter. Select the appropriate AC plug adapter and insert it into the slot that remains after removing the slide-out plate. Slide the new plug adapter into the slot until it snaps into place. You may also leave the adapter slot cover in place and plug in a standard computer equipment AC power cord (purchased separately) between the AC cord receptacle on the end of the power supply and an electrical outlet. QS007306-0810 3 of 5 Application Note: ZMOTIONTM Detection Module Evaluation Kit Step 4: Ensure Jumpers, Switches and Pot's are Configured Correctly Ensure that the base board is configured as shown in the following table. H/W Mode Demonstration Settings: Component SW1 J7 ­ PA1/ANA3 J11 ­ STATE R3 ­ SENS R4 ­ DELAY R6 ­ AMBIENT Status Hardware AMBIENT (ON on shunted) RUN (OFF or un-shunted) Set mid-way Turned all the way to "-" Turned all the way to "-" or "Light" Step 5: Apply Power Connect the power supply to the evaluation board at P2, then to an electrical outlet. Ensure that the green LED (D2) comes on. Step 6: Demonstrate After no more than about 30 seconds, generate motion in front of ZMOTIONTM Detection Module and notice the blue LED D1 to flash ON for about 2 seconds. Adjust R3 (Sense) to change the sensitivity to motion Adjust R4 (Delay) to change the time that the LED stays on Adjust R6 (Ambient) to change the amount of ambient light allowed to stop the LED from turning on For additional information please refer to the ZMOTIONTM Detection Module Evaluation Kit Users Manual UM0223. QS007306-0810 4 of 5 Application Note: ZMOTIONTM Detection Module Evaluation Kit Warning: DO NOT USE IN LIFE SUPPORT LIFE SUPPORT POLICY ZILOG'S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS PRIOR WRITTEN APPROVAL OF THE PRESIDENT AND GENERAL COUNSEL OF ZILOG CORPORATION. As used herein Life support devices or systems are devices which (a) are intended for surgical implant into the body, or (b) support or sustain life and whose failure to perform when properly used in accordance with instructions for use provided in the labeling can be reasonably expected to result in a significant injury to the user. A critical component is any component in a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system or to affect its safety or effectiveness. Document Disclaimer ©2010 by Zilog, Inc. Information in this publication concerning the devices, applications, or technology described is intended to suggest possible uses and may be superseded. [. . . ] XP, ZMOTION, and Zdots are trademarks or registered trademarks of Zilog, Inc. All other product or service names are the property of their respective owners. QS007306-0810 5 of 5 [. . . ]