User manual ZIBRO R27C

[. . . ] Only use Class C1 paraffin fuel in accordance with BS2869: Part 2, or equivalent. Your Zibro Kamin heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Plus. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. Always refer to your local Zibro Kamin dealer for the right fuel for your heater. [. . . ] When you hold down the key, the value will continue going up, until you release the key again. After approximately 10 seconds the blinking will stop and the setting will be locked. 5 Minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. E: When the CLOCK indicator light stops blinking, the setting has been locked to the indicated value. When used for the first time, a new heater may give out a smell for a short while. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. First press either of the two keys to MIN) to set switch on the function (the TEMP light next to the information display ¹ will start blinking). Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( HOUR) to lower the temperature. Without the 'SAVE' setting your heater will maintain the set temperature by Approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. When the indicator light FUEL lights up, it means that there is only fuel left for 10 more minutes. The count-down of the remaining heating time can be seen in the information display ¹ (fig. Now you have two options: you remove the fuel tank and refill it outside the living room (section B) or you push the button EXTENSION . K: When the FUEL indicator light is lit, the information display will show the number of minutes of fuel left in the tank. At the arrival of 10, you will hear an alarmsignal every two minutes, warning you to refill the removable tank. The fuel indicator light will blink, while four lines (--:--) are blinking in the information display. Once the heater has used up all its fuel and extinguished, it will take some time, after the refill, before the heater is completely ready for use again. After the refill, before the heater is completely ready for use again. When the VENT indicator light starts blinking, this is a sign that the room is not vented sufficiently (Fig. [. . . ] The following provisions shall apply regarding this warranty: 2 Any repairs or replacements of components within the term of warranty will not result in an extension of the term of warranty. 3 The warranty shall no longer apply, when the heater has been modified, non-original parts have been used, or when it is repaired by third parties. 4 The warranty shall not apply to parts that are subject to normal wear, such as the burner mat and the manual fuel pump. 5 The warranty shall only apply, when you present the original, dated proof of purchase, provided no changes have been made to it. [. . . ]