User manual ZIBRO R102C

[. . . ] Lid for removable tank 6 After igniting the heater it will take 10 to 15 minutes before you can check if the heater burns well (refer to Section D). Removable tank Fuel gauge removable tank 7 Switch off the heater (refer to Section E). The first time you ignite your heater it will smell like 'new' for a short time. The right quality of fuel will be assured, when you use Zibro Plus for your heater. If you change to another brand and/or type of paraffin oil, you must first finish up all the remaining fuel in the heater. Wick height lock Spark ignition 4 51 WHAT YOU NEED TO KNOW IN ADVANCE ALWAYS MAKE SURE THAT THERE IS SUFFICIENT VENTILATION For each model the minimum size of space is specified in which you can use the heater safely, without additional ventilation (refer to Section K). If a particular room is smaller than the specified space, always leave a window or door slightly ajar ( 2. 5 cm). [. . . ] If you apply more pressure you may turn it slightly further; however, it will automatically return to the start position. When you have set the wick to its highest position, this action will automatically activate the safety device. 4 54 E After having ignited the heater, always check whether the combustion D chamber is level, by sliding it slightly to the left and the right by its handle (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. BURNING OF THE HEATER After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. R). E F M N If the flame remains low after the adjustment, the wick height must be adjusted (refer to Section F). Burning that is too low may be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section M) This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater for more than 5 seconds. To switch the heater on again, put the exchange tank back and follow the steps in section C. SWITCHING OFF THE HEATER Push the OFF-button . The flame will extinguish after a little while. ADJUSTING THE WICK HEIGHT After a period of time the combustion may no longer be high enough (Section D). 2 Pull the knurled wick adjustment knob off the heater, so the wick height lock will be visible. 3 Take the plastic collar between your thumb and index finger and pull it out. This can be done in one way only - check the rear of the cap for the correct position. 4 55 G O If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section H). If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick, refer to section M. If the flame gets too high after adjusting (Fig R), the wick height lock should be placed one position lower again. Otherwise smoke or soot may be caused. MALFUNCTION, CAUSES AND SOLUTIONS If any malfunctioning cannot be solved from the directions below, please contact your dealer. THE HEATER DOES NOT IGNITE The batteries are not positioned correctly in the holder. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS The combustion chamber has not been positioned correctly. Use the handle to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). Follow the procedure on the next page: 1 Ignite the heater outside the living room and let it burn until all fuel is used. 3 Clean the heater with a damp cloth and then dry it with a dry cloth. [. . . ] Check that it is level by sliding it slightly to the left and the right by its handle. Close the grill. 15 a 15 b 16 Put the filled removable tank back into position. Put the batteries into the battery holder (ensure that the positive and negative poles match the + and marks indicated on the battery housing). Wait 30 minutes after replacing the tank and batteries before using the heater. 15 c 15 d 1 6a 16 b 4 61 # # R DISTRIBUTED IN EUROPE BY PVG INTERNATIONAL BV i STERREICH PVG Austria VertriebsgmbH Salaberg 49 3350 HAAG tel: +43 7434 44867 fax: +43 7434 44868 email: pvgaustria@zibro. com e BELGI PVG Belgium NV/SA Industrielaan 55 2900 SCHOTEN tel: +32 3 326 39 39 fax: +32 3 326 26 39 email: pvgbelgium@zibro. com q SCHWEIZ PVG Schweiz AG Genuastrasse 15 4142 MNCHENSTEIN tel: +41 61 337 26 51 fax: +41 61 337 26 78 email: pvgint@zibro. com 2 DEUTSCHLAND PVG Deutschland GmbH Beiersdorfstrae 4 46446 EMMERICH tel: +49 2821 76713 fax: +31 412 648385 email: pvgint@zibro. com 6 DANMARK PVG Scandinavia A/S Niels Bohrsvej 10 6100 HADERSLEV tel: +45 73 53 02 02 fax: +45 73 53 02 04 email: pvgdenmark@zibro. com 5 ESPAA PVG Espaa S. A. [. . . ]