User manual ZIBRO P100

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ZIBRO P100. We hope that this ZIBRO P100 user guide will be useful to you.


ZIBRO P100 : Download the complete user guide (2110 Ko)

You may also download the following manuals related to this product:

   ZIBRO P100 (1478 ko)
   ZIBRO P100 (1478 ko)
   ZIBRO P100 (2114 ko)
   ZIBRO P100 (2114 ko)
   ZIBRO P100 (2114 ko)

Manual abstract: user guide ZIBRO P100

Detailed instructions for use are in the User's Guide.

[. . . ] If you are in any doubt about the electrical installation, have it checked and if necessary modified by a qualified electrician. do not clean the air conditioner by spraying it or immersing it in water. Disconnect from the mains before cleaning the unit or any of its components. [. . . ] This length has been designed especially according to the specifications of the air conditioner. Do not use an extension or exchange for a different hose as that may lead to malfunctioning. The exhaust air must flow freely, any blockage can lead to overheating of the air conditioner. The unit selects the mode depending on the room temperature: higher than 23°C, cooling mode; between 20°C and 23°C, fan mode. 5 Temperature selection Set the temperature that must be maintained (in the range from 16°C to 30°C) with switched 6 Digital display When the unit is ON the display shows the room temperature ( or to see the set temperature ( room temperature will again be displayed. 7 `SLEEP' setting This setting can only be used when the cooling function is activated. Every hour the temperature setpoint will raise with 1°C, after 2 hours the temperature remains the same. Remote control The air conditioner can be operated with remote control. The compressor has been set so that it starts functioning three minutes after the (re)start of the air conditioner. The cooling will switch off when the room temperature is lower than the set one. When the room temperature rises above the selected value, the cooling will work again. The Zibro Clima comfort line air-conditioners are equipped with a 3 layer filter package to clean the circulated room air. The Active carbon sheet can be cleaned with a vacuum cleaner when dusty but has to be changed at the same time as the 3M Filtrete filter. the positive/negative electro statically charged 3M Filtrete filter is recommended to be changed every 3 months. Unusual dirt, construction work, pets, the presence of smokers and running the air-conditioning unit continuously can shorten the life time of the 3M Filtrete filter. To run the unit without Active carbon sheet and/or 3M Filtrete package does not bring any harm to the air-conditioner. The power LED changes to green when the water tank is full, the compressor is stopped and the fan only circulates the air. 4 Remove the rubber plug and fill the water tray then replace the plug to stop the water flow. [. . . ] Components subject to normal wear, such as the filter, are not covered by the guarantee. The guarantee is valid only when you present the original, dated purchase invoice and if no modifications have been made. The guarantee is invalid for damage caused by neglect or by actions that deviate from those in this instruction booklet. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ZIBRO P100




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ZIBRO P100 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.