User manual ZANKER INTEGRAT60/2BWN

[. . . ] Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances, unless they are approved for this purpose by the manufacturer. electrician or competent person ¥ This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts. [. . . ] ManufacturersÕ storage recommendations should be strictly adhered to. The inner lining of the appliance consists of channels through which the refrigerant passes. If these should be punctured this would damage the appliance beyond repair and cause food loss. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ Service/Repair ¥ 10 ¥ Any electrical work required to install this appliance should be carried out by a qualified damage to the appliance. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. Never use metal objects for cleaning your appliance as it may get damaged. is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recicable. Installation ¥ During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. Rinse and dry thoroughly. Interior light The light bulb inside the refrigerator compartment can be reached as follows: - unscrew the light cover securing screw. If the light does not come on when the door is open, check that it is screwed into place properly. The rating is shown on the light bulb cover. D411 13 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. Important: Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a maechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. D037 CUSTOMER SERVICE AND SPARE PARTS If the appliance is not functioning properly, check that: ¥ ¥ ¥ ¥ the plug is firmly in the wall socket and the mains power switch is on; there is an electricity supply (find out by plugging in another appliance); the thermostat knob is in the correct position. If there are water drops on the bottom of the cabinet, check that the defrost water drain ¥ opening is not obstructed (see ÒDefrostingÓ section). If your appliance is still not working properly after making the above checks, contact the nearest service centre. To obtain fast service, it is essential that when you apply for it you specify the model and serial number of your appliance which can be found on the guarantee certificate or on the rating plate located inside the appliance, on the bottom left-hand side. INSTALLATION Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Two adjustable feet at the cabinet base allow accurate levelling of the appliance. 14 100 mm A 10 mm B 10 mm NP007 Rear spacers In the bag with the documentation, there are two spacers which must be fitted in the two top corners. [. . . ] Fit the spacers into the holes, taking care to ensure that the arrow (A) is positioned as shown in figure. Then turn them through 45¡ (arrow (A) vertical) until they lock into place. 45° PR60 A Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. [. . . ]