User manual ZANKER BM1200

[. . . ] Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. ried out by inexperienced persons will cause injury or serious malfunctioning. Always insist on genuine spare parts. General safety · Dishwasher detergents can cause chemical burns to eyes, mouth and throat. Comply with the safety instructions of the dishwasher detergent manufacturer. [. . . ] The higher the content of these minerals and salts, the harder your water is. Water hardness is measured in equivalent scales, German degrees (°dH), French degrees (°TH) and mmol/ l (millimol per litre - international unit for the hardness of water). The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can advise you on the hardness of the water in your area. The water softener must be set in both ways: manually and electronically. 9 Water hardness °dH 51 - 70 43 - 50 37 - 42 29 - 36 23 - 28 19 - 22 15 - 18 11 - 14 4 - 10 <4 °TH 91 - 125 76 - 90 65 - 75 51 - 64 40 - 50 33 - 39 26 - 32 19 - 25 7 - 18 <7 mmol/l 9, 1 - 12, 5 7, 6 - 8, 9 6, 51 - 7, 5 5, 1 - 6, 4 4, 0 - 5, 0 3, 3 - 3, 9 2, 61 - 3, 2 1, 9 - 2, 5 0, 71 - 1, 8 < 0, 7 Adjusting the water hardness setting manually 2 2 2 2 2 2 1 1 1 1 electronically level 10 level 9 level 8 level 7 level 6 level 5 level 4 level 3 level 2 level 1 Use of salt yes yes yes yes yes yes yes yes yes no Setting the water softener manually (see table) The water softener is factory set at position 2. Set switch to position 1 or 2 Setting the water softener electronically (see table) The water softener is factory set at position 5. 10 A B 1. Press and hold Programme selection/ Cancel button until programme light A flashes and programme light B illuminates with fixed light. After a few seconds: ­ programme light B turns off ­ programme light A goes on flashing ­ End of programme light starts flashing: the number of flashes corresponds to current level set. Each time the button is pressed the level increases (level 1 follows level 10). To memorise the operation, switch off the dishwasher. Filling with dishwasher salt CAUTION!Use only special salt suitable for dishwashers. Unscrew the cap. Only before filling with Using the funnel provided, salt for the first time, fill pour in the salt until the the salt container with wa- container is filled with salt. Water will overflow from the container as salt is added. Remove any trace of salt. Never 17 use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run the wash programme for heavy soiled dishes using detergent but without dishes. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Avoid over tilting the machine during transportation. Prolonged periods of nonoperation If you are not using the machine for any prolonged period of time you are advised to: 1. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Environment concerns Packaging material The packaging materials are environmentally friendly and can be recycled. Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities. When a unit is no longer being used: · Pull the plug out of the socket. This prevents children from trapping themselves inside and endangering their lives. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. [. . . ] 21 Test in accordance with EN 50242 must be carried out when the salt container and rinse aid dispenser have been filled with salt and rinse aid respectively and using the test programme (see "Consumption values"). Full load: 12 standard place settings Amount of detergent required Rinse aid setting 5 g + 25 g (Type B) position 4 (Type III) Upper basket Cutlery basket Lower basket cup racks: position A Installation WARNING!Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. Water connection WARNING!The dishwasher must not be connected to open water appliances or instantaneous water heaters. Only use, for connection to the water mains, new hose-set; old hose-set must not be reused. [. . . ]