User manual YURAKU YUR.VISION YV19WB3 BROCHURE

[. . . ] · Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause serious damage to the appliance. Use only a cart or stand recommended by the manufacturer or sold with the monitor. If you mount the monitor on a wall or shelf, use a mounting kit approved by the manufacturer and follow the kit instructions. [. . . ] · To ensure satisfactory operation, use the monitor only with UL-listed computers which have appropriately configured receptacles marked between 100 - 240 V AC, Min. · The wall socket should be installed near the equipment and should be easily accessible. YUR. VISION YV19WB3 3 17NOV04 For Your Safety Special Notes on LCD Monitors The following symptoms are normal with an LCD monitor and do not indicate a problem: · Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker disappears. · You may find slightly uneven brightness on the screen depending on the desktop pattern you use. It may include blemishes of 0. 01% or less such as a missing pixel or a pixel lit all of the time. · Due to the nature of the LCD screen, an afterimage of the previous screen may remain after switching from an image that has been displayed for hours. · The life of the fluorescent light used in the LCD monitor is approximately 20, 000 hours. Contact your dealer or EPI service center for replacement when the screen is dark, flickering or not lighting up. Never attempt to replace it by yourself. YUR. VISION YV19WB3 General Notes · Do not install the monitor near heat sources such as radiators or air ducts. · Do not place monitor in direct sunlight or in areas with excessive dust, mechanical vibration or shock. · Save the original shipping carton and packing materials in case you need to ship your monitor. If the OSD window is open, this button allows you to move within the window and select desired functions. If the OSD window is open, this button allows you to move within the window and select desired functions. MENU: Press this button to open the OSD window or exit from the OSD window. YUR. VISION YV19WB3 Power Indicator: A green light indicates that the monitor is on. On-screen Display (OSD): Press the MENU button to open the OSD window and adjust settings on your monitor. (See next page. ) 10 17NOV04 Operating Instructions Adjusting the OSD Settings YUR. VISION YV19WB3 1. Press the < or > buttons until the desired function is highlighted. Press the < or > buttons to change the settings of the function. YUR. VISION YV19WB3 5. To save and exit, highlight the EXIT icon and press MENU or leave the monitor alone for 10 seconds. Note: When the OSD window is open, the input signal timing settings appear at the top. H: stands for horizontal frequency and V: stands for vertical frequency. 11 17NOV04 Operating Instructions Plug & Play DDC1/2B Feature This monitor is equipped with VESA DDC1/2B capabilities according to the VESA DDC STANDARD. [. . . ] · Inspect the video cable and make sure that none of the pins are bent. (YURAKU monitor drivers are available at: www. YURAKUdisplay. com) · Adjust the Contrast and Brightness settings. · Press a key on the keyboard or wiggle the mouse to re-activate the monitor. · Make sure the video cable is properly connected to the computer. [. . . ]