User manual YORKVILLE CV-1

[. . . ] Precautions should be taken so that the grounding scheme on the unit is not defeated. An apparatus with CLASS I construction shall be connected to a Mains socket outlet with a protective earthing ground. Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Do not place this product on an unstable cart, stand, tripod, bracket or table. [. . . ] Do not place this product on an unstable cart, stand, tripod, bracket or table. The product may fall, causing serious personal injury and serious damage to the product. Use only with cart, stand, tripod, bracket, or table recommended by the manufacturer or sold with the product. Follow the manufacturer's instructions when installing the product and use mounting accessories recommended by the manufacturer. Only use attachments/accessories specified by the manufacturer Note: Prolonged use of headphones at a high volume may cause health damage on your ears. The apparatus should not be exposed to dripping or splashing water; no objects filled with liquids should be placed on the apparatus. Terminals marked with the "lightning bolt" are hazardous live; the external wiring connected to these terminals require installation by an instructed person or the use of ready made leads or cords. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. No naked flame sources, such as lighted candles, should be placed on the apparatus. Do not defeat the safety purpose of the polarized or grounding-type plug. The color fade speeds are fairly slow and are intended for gradually changing mood lighting. It is necessary to connect to an internal circuit board with a jumper cable supplied with the DMX module. Operating instructions for the DMX mode are supplied with the DMX module. When operating with the Yorkville Sound LP-608 lighting controller the COLOR controls on the LPLED4 remain active. The COLOR control can be used to select the color of each fixture or if the COLOR control is set to off then the LP-608 intensity control becomes the color control (including off) but the intensity is not controllable. The automatic level circuitry allows it to be used with signals from weak line levels up to strong loudspeaker levels. When the first unit in the chain is not receiving a control signal its controls are active and the downstream units operate identically to the first unit. The CV-1 will mount on a standard loudspeaker stand or C clamps can be fitted to any of the 4 threaded mounting points. Not only does the unit give off much less heat but also consumes less than 5% to 20% of the energy. This eliminates the need for separate AC power circuits just to run the lights. [. . . ] The CV-1 will mount on a standard loudspeaker stand or C clamps can be fitted to any of the 4 threaded mounting points. Not only does the unit give off much less heat but also consumes less than 5% to 20% of the energy. This eliminates the need for separate AC power circuits just to run the lights. Power consumption is under 270 watts depending on color choice and intensity. [. . . ]