User manual YAMAHA YS-624WE SUPPLEMENTARY SERVICE MANUAL

[. . . ] 1) To obtain warranted service, you will be required to provide to either Onga state office or recommended service agent:a) the product; b) confirmation in writing specifying the nature of your claim; c) proof providing date of original purchase; d) full contact details including name and address; e) the serial number of the product if any. 2) The product is to be forwarded by the customer freight paid to an Authorised Onga service agent. Infield service by an authorised Onga Service Agent will incur a travel, removal & reinstallation fee to adjudicate on warranty issues. Authorised warranty will be free of charge for the first 12 month period from date of the first consumer purchase. [. . . ] Switch the power to the pump off and allow the motor to cool before switching back on. Ensure that the pump and motor have adequate ventilation in the area surrounding the pump. Ensure that the pump is not jammed with debris and that the motor shaft spins freely. Check the plumbing to ensure the valves are in the correct position for filtering, including any valves on the suction or discharge of the pump. Clean the filter (refer to the documentation supplied with your filter). Ensure the water level in your pool is at least up to the halfway mark at the skimmer opening. Ensure that both the hair & lint pot basket and skimmer basket are free of leaves and other debris. Ensure that the pump internals are free of foreign matter which may impede the flow of water. Check alignment and condition of casing O'ring before retightening the bolts. Replace the mechanical seal and lip seal (if fitted). Installation Incorrectly installed or tested equipment may fail, causing severe injury or property damage. Read and follow instructions in owner's manual when installing and operating equipment. Fittings: Fittings restrict flow; for best efficiency use fewest possible fittings. Pool outlets: Use only non-entrapping suction fittings or double suction conforming with the AS1926. 3-2003 Standard, or local authority requirements. 3. 4. 6. Pump Service Pump should only be serviced by qualified personnel. For best results, use only genuine Onga factory parts. Be sure to prime pump before starting. NEVER tighten or loosen lid while pump is operating! To avoid dangerous or fatal electrical shock hazard, turn OFF power to motor and remove plug from power outlet before working on pump or motor. No lubrication or regular maintenance is needed beyond reasonable care and periodic cleaning of strainer basket. When pump is not in use and there is a risk of frost, empty it completely through the drain plug. The fittings on these pool pumps are constructed of ABS. Some PVC jointing compounds are incompatible with ABS possibly causing failure to the product. Check compound suitability prior to use. 14 7 INSTALLATION (Continued) All glued fittings and pipe work should be allowed to dry to atmosphere for 24 hours before closing installation. Barrel Unions are to be hand tightened ONLY, to prevent damage occurring from over-tightening. Operation (Continued) Priming Pump Release all air from filter, pump and piping system: refer filter owner's manual. In a flooded suction system (water source higher than pump), pump will prime itself when suction and discharge valves are opened. If pump is not in a flooded suction system, disconnect power supply to pump and remove hair & lint pot lid; fill casing & bowl with water. [. . . ] NOTICE: Maximum ambient temperature for motor operation must not exceed maximum ambient tempearture rating. This appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised at all times when near this appliance. Pool Pump Suction Requirements Pump suction is hazardous and can trap and drown or disembowel bathers. Do not use or operate swimming pools, spas, or hot tubs if a suction outlet cover is missing, broken, or loose. [. . . ]