User manual YAMAHA YC45D

[. . . ] NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regula* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. [. . . ] Use the / lect a memory number (01 ­ 128), then press the recall those settings from memory. ) When the Utility Mode is engaged, these switches are used to switch MIDI functions and the Speaker Simulator ON or OFF, etc. ) * When the Amp Select button is pressed, knobs r ­ y return to their preset positions (GAIN and MASTER =7, Tone Controls all = 5). * To protect the speakers from possible damage, always set the OUTPUT e volume to "0" before turning the power ON/OFF. 8 Before making any connections, make sure that the power on the YC45D and any external devices is switched OFF. OUT YC45D internal speaker or a speaker with an impedance of 4-8 and can handle 100W or more. MIDI IN Store data from the YC45D's internal memory to a MIDI device. If necessary, you can disconnect the internal speaker and connect an external speaker to this jack. If an external speaker is used, make sure that the speaker meets the following requirements. Connect this jack to the MIDI IN jack of a device that can save MIDI data. the data stored in the YC45D's internal memory can then be transmitted to an external MIDI device for storage. Choose one of the YC45D's eight preset amp types, then use the GAIN+MASTER, and tone controls to shape the guitar's sound. Use the GAIN, MASTER, and the five tone controls to shape the guitar's sound. Volume levels for individual memory settings should be set with the MASTER knob. The speaker's output level should be controlled with the OUTPUT knob. * When an AMP SELECT button is pressed, all knobs (except TRIM, OUTPUT and REVERB) will return to their preset positions. With the procedures on this page, you can create an original sound (settings), and along with the reverb and echo settings they can be stored in the DG100212's internal memory for instant recall at anytime. The procedure for storing data in memory is explained on the next page. motor drives in the knobs will automatically set the knobs to the corresponding positions. Use the procedure on page 8 and create a sound using the eight preset amp types and control knobs on the front panel. * Each of the Utility Mode's settings cannot be stored in individual memory. When the power is switched OFF, each memory's settings are stored in memory as common settings. [. . . ] You can control the YC45D's overall volume from an external MIDI device using a number 7 control change message (main volume) sent from the MIDI OUT jack of an external MIDI device to the YC45D's MIDI IN jack. , or a MIDI device equipped with a foot pedal, you can use the foot pedal to control the volume during performance. Using the following three positions, you can select the control position as to where the volume is changed. The YC45D's speaker simulator provides the line signal with a realistic simulation of the natural sound of a speaker. [. . . ]