User manual YAMAHA YAS-101

[. . . ] Fm Page 1 Friday, September 9, 2011 10:51 AM AVEEA71102B G Important Notice: Guarantee Information for customers in EEA* and Switzerland English For detailed guarantee information about this Yamaha product, and Pan-EEA* and Switzerland warranty service, please either visit the website address below (Printable file is available at our website) or contact the Yamaha representative office for your country. Com/warranty/ OWNER’S MANUAL MODE D’EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING © 2011 Yamaha Corporation Printed in Malaysia ZA79070 Caution: Read this before operating your unit. 1 2 To assure the finest performance, please read this manual carefully. Install this unit in a well ventilated, cool, dry, clean place - away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. [. . . ] 1 Up Down Press and hold AUDIO DELAY more than 3 seconds to enter adjustment mode. The color of qD DTS indicator changes depending on the adjustable range. Green indicates a lower volume level, orange a moderate level, and red a higher level. Note Note that when the qD DTS indicator is red, the volume is set to a higher level. (+ increases the delay time) y To turn off the volume temporarily, press MUTE. Make the delay time longer Make the delay time shorter Adjust the subwoofer level Press SUBWOOFER +/– to adjust the bass level. Green indicates a minus level, orange a standard level (default value is 0), and red a plus level. The color of qD DTS indicator changes depending on the adjustable range. Green indicates a shorter delay time, orange a medium delay, and red a longer delay. Y The adjustment mode is canceled if the unit is left for 20 seconds without any operation being performed. Additional Information Using an external subwoofer Although the unit has a subwoofer built-in, you can use commercially available powered subwoofer of your choice. The SURROUND indicator (for 2 seconds after the unit is turned on) Built-in subwoofer External subwoofer 1 2 Set the unit to standby mode. Press both the VOLUME – button and button of the main unit, release the button first, then release the VOLUME – button. This unit is turned on when switching between the built-in subwoofer and external subwoofer. € You can verify the current setting by turning the unit on again from standby mode. Note You cannot use the built-in subwoofer and the external subwoofer simultaneously. 8 En Additional Information Operation by the TV remote control is difficult (with unit beneath/under TV) TV remote control operation may be difficult if the unit hides the sensor of your TV when beneath or under the TV. 2 English Press both the VOLUME + button and button of the main unit, release the button first, then release the VOLUME + button. The unit is turned on when switching the TV remote control signal transmission function on/off. 11) On The CLEAR VOICE indicator (for 2 seconds after the unit is turned on) 1 Move the unit in all directions. € You can verify the current setting by turning the unit on again from standby mode. Notes • Move the unit in all directions again if TV remote control remains difficult. [. . . ] The TV remote control is not compatible with the TV remote control signal transmission function. Place the unit (without the stands, for example) so as not to hide the remote control sensor of your TV. 9 9 9 9 The TV remote control is not The unit and TV are too close/far from one working even if you use the another. The unit obstructs the 3D glasses transmitter of Check the position of 3D glasses transmitter of your TV. [. . . ]