User manual YAMAHA TP-126C

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual YAMAHA TP-126C. We hope that this YAMAHA TP-126C user guide will be useful to you.


YAMAHA TP-126C : Download the complete user guide (709 Ko)

Manual abstract: user guide YAMAHA TP-126C

Detailed instructions for use are in the User's Guide.

[. . . ] Please read through this manual carefully as it contains important information about your instrument's care. In order to prevent damage or injury, we urge you to carefully read and follow the instructions listed below. [. . . ] The standard striking point lies at distance B from the kettle edge, which corresponds approximately to 1/4 to 1/3 of the distance between the kettle edge and the center of the head (A). â· Sound is higher than the tuning note Loosen the tuning bolts by the same amount in the order shown below. When loosening the tuning bolts, always loosen them by double the desired amount, and then return (re-tighten) them by half. When the sound lies within 1 halftone below the desired pitch after loosening the tuning bolts (repeatedly, if necessary), proceed with step 2. Tighten the other bolts little by little (by about 1/16 to 1/8 of a turn) until the sounds at the corresponding striking points match the pitch of the highest sound. please note that tightening one bolt also raises the pitch at neighboring and opposite tuning bolts. Thus, after tightening the tuning bolt with the lowest sound, again check the pitch at the other tuning bolts before tightening the tuning bolt with the next lowest pitch. Loosen all over-tightened bolts according to the procedure described in step 1. Once the pitch is attained, use the palm of your hand and lightly push the head at its center a few times to settle the head. Tuning is complete when the pitch does not change after pushing the center of the head. [. . . ] In the proper order, tighten the tuning bolts alternately until the head is tensioned slightly. At this time, make sure that the head and hoop are centered on the kettle. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE YAMAHA TP-126C




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual YAMAHA TP-126C will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.