User manual YAMAHA STAGEPAS 400I

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual YAMAHA STAGEPAS 400I. We hope that this YAMAHA STAGEPAS 400I user guide will be useful to you.


YAMAHA STAGEPAS 400I : Download the complete user guide (5292 Ko)

You may also download the following manuals related to this product:

   YAMAHA STAGEPAS 400I (5918 ko)
   YAMAHA STAGEPAS 400I (4718 ko)
   YAMAHA STAGEPAS 400I (4702 ko)
   YAMAHA STAGEPAS 400I (3266 ko)
   YAMAHA STAGEPAS 400I (4703 ko)
   YAMAHA STAGEPAS 400I (4717 ko)
   YAMAHA STAGEPAS 400I (4725 ko)
   YAMAHA STAGEPAS 400I (4704 ko)
   YAMAHA STAGEPAS 400I ANNEXE 1 (1403 ko)

Manual abstract: user guide YAMAHA STAGEPAS 400I

Detailed instructions for use are in the User's Guide.

[. . . ] ZC57930 EN PORTABLE PA SYSTEM Connecting microphones, instruments, and audio devices to the mixer Applying Reverb The STAGEPAS 400i features a built-in reverb processor that is in the same league as our famed SPX effect processor series. This reverb lets you simulate the acoustics of different performance environments, such as concert halls and small clubs, and add warm, natural ambience to your vocals or instrument performance. 5 MONITOR OUT jacks These are for connection to a powered speaker for monitoring purposes, and output a mix of the signals from channels 1 to 7/8. If only the L (MONO) jack is used, the signals from the L and R channels are mixed and output. 9 USB connector Connect your iPod/iPhone using a USB cable to play music and charge the iPod/iPhone. Use the LEVEL control of channels 7/8 to adjust the volume, since the music signals are mixed to those channels. [. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The above warning is located on the bottom of the mixer. IMPORTANT SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. Read these instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding-type plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over. 13. Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. No sound is heard. …… you connect the mixer’s SPEAKERS Did jacks and the speakers’ input jacks using the proper speaker cables?…… a speaker other than the included Is speaker (MODEL 400S) connected to the mixer’s SPEAKERS jacks?If you use a commercially-available speaker cable with a metal-housing connector, the cable will be shorted when the connector touches other metal, resulting in no sound being produced. Is There may be a short in the speaker cable or the connection may be faulty. Check that the speaker cable is not scratched and is connected properly to the mixer, then reapply the power. …… channels 5/6, are both phone and For RCA-pin jacks connected at the same time?Or, for channels 7/8, are both phone and stereo mini jacks connected at the same time?The phone jack has priority for channels 5/6 and the stereo mini jack has priority for 7/8. If the internal power amplifier section is excessively overloaded, the amplifier will be muted for protection. The mixer will automatically reset itself after a while. Phantom Voltage +30 V (CH1, 2) Speaker Unit LF: 8” (20 cm) Cone HF: 1” (2. 54 cm) Compression Driver If you notice any abnormality • When one of the following problems occur, immediately turn off the power switch and disconnect the electric plug from the outlet. • If this mixer should be dropped or damaged, immediately turn off the power switch, disconnect the electric plug from the outlet, and have the device inspected by qualified Yamaha service personnel. Connections • Before connecting the device to other devices, turn off the power for all devices. Before turning the power on or off for all devices, set all volume levels to minimum. • For the SPEAKERS jacks of the mixer, use only the included MODEL 400S speakers and speaker cables. Use of other types of speakers and cables may result in damage, or even fire. Weight 17. 8 kg (39. 2 lbs) (Speaker 7. 5 kg x 2 + Mixer 2. 8 kg) Crossover Frequency 3. 2 kHz Package Contents Sound is not loud enough …… Are the LEVEL controls of all relevant channels and/or the MASTER LEVEL control set too low? [. . . ] If a loudspeaker cabinet loses high-frequency output, immediately remove power from the unit and wait for two to three minutes. Reapply power and check the performance of the highfrequency driver before continuing, with the power reduced to a level that does not cause the poly switch to interrupt the signal. • Interference from cell phones Using a cell phone near the speaker system can induce noise. If this occurs, move the cell phone further away from the speaker system. • Air blowing out of the bass reflex ports is normal, and often occurs when the speaker is handling program material with heavy bass content. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE YAMAHA STAGEPAS 400I




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual YAMAHA STAGEPAS 400I will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.