User manual YAMAHA RX-797

[. . . ] G RX-797 Stereo Receiver Récepteur stéréo OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING GEBRUIKSAANWIJZING CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 1 To assure the finest performance, please read this manual carefully. 2 Install this sound system in a well ventilated, cool, dry, clean place ­ away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. Allow ventilation space of at least 30 cm on the top, 20 cm on the left and right, and 20 cm on the back of this unit. 3 Locate this unit away from other electrical appliances, motors, or transformers to avoid humming sounds. [. . . ] · Check the copyright laws in your country to record from records, CDs, radio, etc. Recording copyright-protected material may infringe on copyright laws. 4 Rotate VOLUME on the front panel (or press VOLUME +/­ on the remote control) to adjust the sound output level of the selected source to record from. 16 20 VOLUME 12 26 8 40 4 or VOLUME 60 2 0 -dB ZONE 2 ON/OFF FM/AM l TUNING h PURE DIRECT CD DIRECT AMP ZONE CONTROL EDIT MEMORY TUNING MODE Front panel Remote control MAN'L/AUTO FM AUTO/MAN'L MASTER SPEAKERS A B 16 A/B/C/D/E 1 2 3 4 5 6 7 8 VOLUME 20 12 26 ON OFF 8 INPUT MAIN ZONE PHONES REC OUT SOURCE MD/TAPE VCR CD TUNER PHONO 3 4 ­5 2 1 BASS 0 1 2 3 4 5+ 3 4 2 TREBLE 1 0 1 2 3 4 ­5 5+ 3 4 2 BALANCE 1 0 1 2 3 4 L5 5R 3 4 2 LOUDNESS 1 FLAT ­30dB 10 9 8 5 6 7 40 4 ON/OFF DTV/CBL DVD 60 2 5 0 -dB Begin recording on the MD recorder, the tape deck or the VCR connected to this unit. 3 1 1 4 Note If you set the REC OUT selector to a source other than the one that you are watching or listening to, selecting another source with the INPUT selector on the front panel (or the corresponding input selector button on the remote control) while recording is in progress will not affect the recording. Rotate the REC OUT selector on the front panel to select the source you want to record from. REC OUT SOURCE MD/TAPE VCR DTV/CBL DVD CD TUNER PHONO y You can monitor the sound and/or picture being recorded by rotating the INPUT selector on the front panel (or pressing MD/ TAPE or VCR on the remote control) to select the MD recorder, the tape deck or the VCR used for recording. To record the current input source that you are watching or listening to, set the REC OUT selector to SOURCE. To record a source other than the one that you are watching or listening to, set the REC OUT selector to the source you want to record. 2 3 Play the selected source to record from. Rotate the INPUT selector on the front panel to confirm the selected source to record from. INPUT 20 PLAYING AND RECORDING Using the sleep timer Use this feature to automatically set this unit to the standby mode after a certain amount of time. The sleep timer is useful when you are going to sleep while this unit is playing or recording a source. The sleep timer also automatically turns off any external components connected to the AC OUTLET(S). POWER TV POWER AV STANDBY 4 Press SLEEP repeatedly so that SLEEP OFF appears in the front panel display. SLEEP POWER After a few seconds, SLEEP OFF disappears from the front panel display, and the SLEEP indicator turns off. y The sleep timer setting can also be canceled by pressing STANDBY on the remote control (or MAIN ZONE ON/OFF or MASTER ON/OFF on the front panel) to set this unit to the standby mode. CD MD/TAPE TUNER 1 DVD DTV/CBL VCR PHONO REC CODE SET SPEAKERS A DISC SKIP B FREQ/TEXT EON SLEEP MODE PTY SEEK START 3 TV VOL TV CH VOLUME Notes · The sleep timer can only be set with the remote control. However, the power of Zone 2 components are not turned off. BASIC OPERATION 1 Press one of the input selector buttons on the remote control to select an input source. POWER TV POWER AV STANDBY POWER CD MD/TAPE TUNER DVD DTV/CBL VCR PHONO 2 3 Start playback on the selected input source. Press SLEEP repeatedly to set the amount of time before this unit is set to the standby mode. Each time you press SLEEP, the front panel display changes as shown below. SLEEP SLEEP 120 min SLEEP OFF SLEEP 90 min SLEEP 60 min SLEEP 30 min The SLEEP indicator flashes while switching the amount of time for the sleep timer. SLEEP English 21 PLAYING AND RECORDING Muting the sound output 1 Press MUTE on the remote control to mute the sound output. The MUTE indicator flashes in the front panel display and MUTE ON appears in the front panel display. MUTE MUTE After a few seconds, MUTE ON disappears from the front panel display. 2 Press MUTE on the remote control again to resume the sound output. The MUTE indicator disappears from the front panel display. MUTE 22 FM/AM TUNING FM/AM TUNING There are 2 tuning methods; automatic and manual. Select either method according to your preference and the strength of station signals. Automatic tuning Automatic tuning is effective when station signals are strong and there is no interference. 4 Press TUNING l / h once to begin automatic tuning. Press l to tune into a lower frequency. l TUNING h 243 ZONE 2 ON/OFF FM/AM l TUNING h PURE DIRECT ZONE CONTROL EDIT MEMORY TUNING MODE CD DIRECT AMP MAN'L/AUTO FM AUTO/MAN'L Notes 16 VOLUME MASTER SPEAKERS A B A/B/C/D/E 1 2 3 4 5 6 7 8 20 12 26 ON OFF 8 INPUT MAIN ZONE PHONES REC OUT SOURCE MD/TAPE VCR CD TUNER PHONO 3 4 ­5 2 1 BASS 0 1 2 3 4 5+ 3 4 2 TREBLE 1 0 1 2 3 4 ­5 5+ 3 4 2 BALANCE 1 0 1 2 3 4 L5 5R 3 4 2 LOUDNESS 1 FLAT ­30dB 10 9 8 5 6 7 40 4 ON/OFF DTV/CBL DVD 60 2 0 -dB 1 1 Rotate the INPUT selector (or press TUNER on the remote control) to select TUNER as the input source. INPUT · When you tune into a station, the frequency of the received station is shown in the front panel display. · If the tuning search does not stop at the desired station because the station signals are weak, try using the manual tuning method. BASIC OPERATION TUNER or Front panel Remote control 2 Press FM/AM on the front panel to select the reception band (FM or AM). FM or AM appears in the front panel display. FM/AM 3 Press TUNING MODE on the front panel so that the AUTO indicator lights up in the front panel display. TUNING MODE AUTO/MAN'L AUTO Lights up English 23 FM/AM TUNING Manual tuning Manual tuning is effective when station signals are weak. 4 Press TUNING l / h to manually tune into the desired station. Hold down the button to continue tuning search. l TUNING h 243 ZONE 2 ON/OFF FM/AM l TUNING h PURE DIRECT ZONE CONTROL EDIT MEMORY TUNING MODE CD DIRECT AMP MAN'L/AUTO FM AUTO/MAN'L 16 MASTER SPEAKERS A B A/B/C/D/E 1 2 3 4 5 6 7 8 VOLUME 20 12 Notes 8 4 2 26 ON OFF INPUT MAIN ZONE PHONES REC OUT SOURCE MD/TAPE VCR CD TUNER PHONO 3 4 ­5 2 1 BASS 0 1 2 3 4 5+ 3 4 2 TREBLE 1 0 1 2 3 4 ­5 5+ 3 4 2 BALANCE 1 0 1 2 3 4 L5 5R 3 4 2 LOUDNESS 1 FLAT ­30dB 10 9 8 5 6 7 40 ON/OFF DTV/CBL DVD 60 0 -dB · When you tune into a station, the frequency of the received station is shown in the front panel display. · If you tune into an FM station, it is automatically received in the monaural mode to increase signal quality. 1 1 Rotate the INPUT selector (or press TUNER on the remote control) to select TUNER as the input source. INPUT TUNER or Front panel Remote control 2 Press FM/AM on the front panel to select the reception band (FM or AM). FM or AM appears in the front panel display. FM/AM 3 Press TUNING MODE on the front panel so that the AUTO indicator disappears from the front panel display. TUNING MODE AUTO/MAN'L AUTO Disappears 24 FM/AM TUNING Automatic preset tuning You can use the automatic preset tuning method to automatically store FM stations. This function enables this unit to automatically tune into FM stations with strong signals and store up to 40 (8 stations in each of the 5 groups, A1 to E8) of those received stations in order. You can then easily recall any preset stations by selecting the preset station numbers where they are stored. Notes · Any station data stored under a preset station number is cleared when you store a new station under that preset station number. [. . . ] 1. 0 µV (11. 2 dBf) · Signal to Noise Ratio (IHF) Mono/Stereo . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76 dB/70 dB · Harmonic Distortion (1 kHz) Mono/Stereo . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 2%/0. 3% · Stereo Separation (1 kHz) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Hz to 15 kHz, +0. 5/­2 dB AM SECTION · Tuning Range [U. S. A. [. . . ]