User manual YAMAHA OUTBOARD MOTOR 15DM

[. . . ] The remote control switch must be equipped with a potential-free contact which is suited for 5 V DC. OUTBOARD MOTOR 15DM is a room temperature regulator with a digital time switch (weekly programme; three heating and one reduction starting times per day) for controlling the gas heating units with continuous control listed below. Before mounting the regulator, the voltage supply (230 V, 50 Hz) to the heating unit must be interrupted. Room temperature regulators like OUTBOARD MOTOR 15DM are not suited for buildings with underfloor heating systems. [. . . ] With this control knob (m) the temperature to which the regulator must regulate in the automatic operating mode when set to "economic", as well as in "economical operation mode" (h). Turn the control knob (n) to The display (e) shows: Select day +/- When no more alterations are necessary close the lid. 4 Control knob set to "Heating" Setting the heating programme The time switch makes it possible to automatically switch on the heating system up to three times a day at a pre-determined time and to automatically switch it off three times a day a pre-determined time. To make programming more effective it is useful to fill in the heating times into the table provided (see chapter 10). The heating programme which is used for most days of the week (also applicable if the times deviate slightly) should be filled in for all days in the first step. In the setting All days both "heating operation" and "economic operation" will start at the respective times each day. Thursday) was selected, the set programme for this day always starts at the pre-set time on this day, i. Each Thursday both "heating operation" and "economic operation" will start at the set times. One single day can be set by depressing the buttons "­" (o) or "+" (p). Briefly depressing the button alters the starting time by 10 minutes, when the button is depressed for a longer period the time runs faster forward or backward. Now the respective first starting time for economic operation must be set. The number of days absent is set by depressing the buttons "­" (o) or "+" (p). Briefly depressing the button alters the number of days absent by 1 day, when the button is depressed for a longer period the displayed days run faster. The day of return should only be entered if no heating operation is required for that day! Example: You would like to leave your house for a two weeks' holiday. Return is planned for Saturday, two weeks later, and you would like the house to be heated by then. If you enter the number of days absent shortly before leaving, the number entered must be "14" (Saturday, Sunday, . Thursday and Friday, since on the Saturday you return you want the regulator to switch the heating system on as usual. The regulator immediately regulates to the temperature set with the control knob (m) The remaining days until you return are always displayed. After the set number of days (at midnight) the regulator automatically terminates economic operation and returns to automatic operation. If you would like to carry out further alterations do not yet close the lid. Tip Please note that the temperature set with the control knob (m) should be harmless to your pets, plants, etc. [. . . ] If the house is left for a longer period you should consider that it could become a lot cooler (walls could cool down etc. 9 Reprogramming If you would like to carry out extensive alterations to the programme it might be better to set the regulator back to the programme preset by the factory and to re-enter all starting times. In this case please proceed as stated in the operating instructions of the heating unit or contact your local expert for heating systems. Turn the control knob (n) to the position until the display (e) shows Select day +/­ then briefly depress the cancel button C (r). [. . . ]