User manual YAMAHA NUAGE FADER GETTING STARTED

[. . . ] NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee * This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. [. . . ] NOTE For details on the Dante Controller, refer to the Dante Controller manual. Insert one plug of the power cable into the [AC IN] terminal on the device. Installing TOOLS for NUAGE To install TOOLS for NUAGE, double-click the installer file you have downloaded from the website. Insert the other plug of the power cable into a proper AC wall outlet. Configuring the Workgroup on NUAGE To configure the Workgroup, open the NUAGE Workgroup Manager then register the devices and DAW software applications to the Workgroup. To open the NUAGE Workgroup Manager manual, double-click the NUAGE Workgroup Manager icon on the task tray (Windows) or menu bar (Mac) for opening the window, then click the “Manual” icon. WARNING Only use the included power cable (or an equivalent recommended by Yamaha). Using the wrong cable can result in damage to the device or overheating. CAUTION Remove the plug of the power cable from the outlet when the device is not be used for extended periods of time, or during electrical storms. NUAGE I/O (16D )/ NUAGE I/O (16A) / NUAGE I/O (8A8D) Operation Manual 11 Description of the Device Description of the Device Front Panel NUAGE I/O (16D) 1 2 4 3 5 6 NUAGE I/O (16A) 1 2 3 5 6 NUAGE I/O (8A8D) 1 2 4 3 5 6 12 NUAGE I/O (16D) / NUAGE I/O (16A) / NUAGE I/O (8A8D) Operation Manual Description of the Device 1 [INPUT level meter] 4 [SRC indicator] Indicates the input signal level of [ANALOG INPUT] (page 16) or [AES/EBU] (page 16) on the rear panel. Lamp Top (red) Second (orange) Third (orange) Bottom (green) Indicates the status of the SRC (sample rate converter), on (lit) or off (unlit). If you change this while the power is on, the new device ID will not be applied. When connecting this connector to NUENDO SyncStation, Nuendo and the devices maintain accurate synchronization with each other. 8 [WORDCLOCK OUT] (BNC connector) Sets the device settings or initializes them. If you change this while the power is on, the settings will not be applied. [Dip switch] Description 1 Selects whether [SECONDARY] (page 15) will operate as a redundant network (page 9) or daisy chain connection (page 9). [SECONDARY] will operate as a redundant network when you turn this on (down), and daisy chain connection when you turn this off (up). Turn the power of the device on, then wait for the [OUTPUT level meter] of the 16 channels to flash at intervals. 9 [WORDCLOCK IN] (BNC connector) For connection to the BNC coaxial cable. ) [CASCADE OUT] (RJ-45 connector) 2 For connection to the Ethernet cable (CAT5e or better recommended). This connector inputs and outputs sixteen channels of audio for the direct monitoring. This is useful when outputting the audio signal to another device with near-zero latency. [. . . ] END OF TERMS AND CONDITIONS How to Apply These Terms to Your New Programs If you develop a new program, and you want it to be of the greatest possible use to the public, the best way to achieve this is to make it free software which everyone can redistribute and change under these terms. It is safest to attach them to the start of each source file to most effectively convey the exclusion of warranty; and each file should have at least the “copyright” line and a pointer to where the full notice is found. Copyright © yyyy name of author This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation; either version 2 of the License, or (at your option) any later version. This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. [. . . ]