User manual YAMAHA NS-PA120

[. . . ] Placing the speakers on the same shelf or rack as the turntable can result in feedback. Any time you note distortion, reduce the volume control on your amplifier to lower setting. When using an amplifier with a rated output power higher than the nominal input power of the speakers, care should be taken not to exceed the maximum input of the speakers. Do not attempt to clean the speakers with chemical solvents as this might damage the finish. [. . . ] 2 En Installing the speakers Wall-mounting the speakers You can mount the speakers on the wall as follows. Wall/wall support 26 mm (1") NS-B150 1 2 Install screws into a solid wall or wall support as shown in the illustration. English Note 3 mm (1/8") Minimum 20 mm (3/4") • Make sure the shaft of the screw is seated in the narrow part of the keyhole slot. Do not mount the speakers on thin plywood or on a wall with a soft surface material. Otherwise, the screws may pull out of the surface and the speakers may fall, possibly damaging the speakers or causing personal injury. € Do not affix the speakers to a wall using nails, adhesives, or unstable hardware. € To avoid accidents resulting from tripping over loose speaker cables, affix the cables to the wall. € Mount the speakers in a wall location that will be unlikely to result in injury to an individual’s head. € When using speaker brackets (commercially available) to mount the speakers on the wall or ceiling, we strongly recommend using safety wire (may be supplied with the bracket) between the speaker and bracket to prevent the speaker from falling. € When installing these speakers on a wall mounted bracket, it is essential that they are firmly secured. Be sure to consult a reliable source about the best type of fastener for your particular wall / ceiling’s construction. 210 mm (8-1/4") NS-C150 ■ Mounting the center speaker on the Yamaha YTS-F500/YTS-T500 TV stand You can use the screw holes [diameter: 6 mm (1/4"), hole depth: 16 mm (5/8")] on the rear of this unit to mount the speaker on the YTS-F500/YTS-T500. For installation details, please refer to the owner’s manual that came with the YTS-F500/YTS-T500. NS-C150 Rear view 290 mm (11-1/2") 95 mm (3-3/4") Use speaker bracket “B” that came with the YTS-F500/YTS-T500. Insert screws “D (M6 x 16)” that came with the YTS-F500/YTS-T500 into the screw holes. NS-C150 (Installation example using YTS-F500) Notes • Be careful not to pinch the speaker cables between the speaker and the speaker bracket or speaker stand. 3 En Connecting the speakers Connecting the speakers Caution: Make sure the power cables for your other AV components are disconnected from the AC wall outlets before making any connections. Connection diagram Front speakers Right Left Center speaker Amplifier Note: The exact layout of the speaker terminals depends on your amplifier. Right Left Right Left Surround speakers Surround back speakers (NS-PA150 only) ■ Preparing the speaker cables Once you’ve positioned the speakers, you’ll need to prepare the speaker cables for connecting the speakers. € Twist the bare wires tightly so the individual strands are not splayed. € Be careful not to injure yourself while preparing the speaker cables. 1 2 Remove about 15 mm (5/8") of insulation from the end of each speaker cable. [. . . ] In the unlikely event that your Yamaha product needs guarantee service, please contact the dealer from whom it was purchased. If you experience any difficulty, please contact Yamaha representative office in your country. The product is guaranteed to be free from defects in workmanship or materials for a period of two years from the date of the original purchase. Yamaha undertakes, subject to the conditions listed below, to have the faulty product or any part(s) repaired, or replaced at Yamaha’s discretion, without any charge for parts or labour. [. . . ]