User manual YAMAHA NEO-S 50-2002

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual YAMAHA NEO-S 50-2002. We hope that this YAMAHA NEO-S 50-2002 user guide will be useful to you.


YAMAHA NEO-S 50-2002 : Download the complete user guide (4152 Ko)

Manual abstract: user guide YAMAHA NEO-S 50-2002

Detailed instructions for use are in the User's Guide.

[. . . ] OWNER'S MANUAL AT115 5MX-F8199-E0 Engine start procedure Before pushing start button, make sure to apply the Front or Rear Brake and that the Sidestand is retracted. Recommended oil : SAE20W - 50 type SF Class Motor Oil V-belt inspection Periodic maintenance must be performed by any authorized Yamaha Dealer (Refer to the Owner's Manual for details. ) Load limit Convenience hook : 1 kg, Helmet box: 5 kg 5MX-F835Y-00 EAU00000 INTRODUCTION Congratulations on your purchase of the Yamaha AT115. This model is the result of Yamaha's vast experience in the production of fine sporting, touring, and pacesetting racing machines. It represents the high degree of craftsmanship and reliability that have made Yamaha a leader in these fields. [. . . ] 6 6-8 PERIODIC MAINTENANCE AND MINOR REPAIR EAUT0016* Engine oil and oil strainer The engine oil level should be checked before each ride. In addition, the oil must be changed and the oil strainer cleaned at the intervals specified in the periodic maintenance and lubrication chart. NOTE: Make sure that the motorcycle is positioned straight up when checking the oil level. Wait a few minutes until the oil settles, remove the oil filler cap, wipe the dipstick clean, insert it back into the oil filler hole (without screwing it in), and then remove it again to check the oil level. 1. Minimum level mark NOTE: The engine oil should be between the minimum and maximum level marks. _ _ 2. Start the engine, warm it up for several minutes, and then turn it off. 4. If the engine oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. 6-9 PERIODIC MAINTENANCE AND MINOR REPAIR To change the engine oil and clean the oil strainer 1. Start the engine, warm it up for several minutes, and then turn it off. Remove the engine oil filler cap and drain bolts to drain the oil from the crankcase. NOTE: When only changing the engine oil, remove engine oil drain bolt A only. _ _ CAUTION: When removing the engine oil drain bolt B, the O-ring, spring, and oil strainer will fall out. Clean the oil strainer with solvent, and then check it for damage and replace it if necessary. Install the oil strainer, spring, O-ring and engine oil drain bolts, and then tighten the drain bolts to the specified torque. 6-10 PERIODIC MAINTENANCE AND MINOR REPAIR ECA00105 Tightening torques: Engine oil drain bolt A: 20 Nm (2. 0 m·kgf) Engine oil drain bolt B: 20 Nm (2. 0 m·kgf) NOTE: Make sure that the O-ring is properly seated. _ _ _ 7. Add the specified amount of the recommended engine oil, and then install and tighten the engine oil filler cap. Oil quantity: Periodic oil change: 0. 8 L Total amount (dry engine): 0. 9 L CAUTION: G In order to prevent clutch slippage (since the engine oil also lubricates the clutch), do not mix any chemical additives with the oil or use oils of grade "CD" or higher. In addition, do not use oils labeled "ENERGY CONSERVING II" or higher. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause. Turn the engine off, and then check the oil level and correct it if necessary. 1. Oil filler cap EAU04228* Final transmission oil The final transmission case must be checked for oil leakage before each ride. If any leakage is found, have a Yamaha dealer check and repair the motorcycle. In addition, the final transmission oil must be changed as follows at the intervals specified in the periodic maintenance and lubrication chart. Start the engine, warm it up by riding the motorcycle for several minutes, and then stop the engine. [. . . ] Place the tail/brake light lens into the original position, and then install the screws. EC000108 CAUTION: Do not overtighten the screws, otherwise the lens may break. _ _ 6. Install the panel. 6-35 PERIODIC MAINTENANCE AND MINOR REPAIR Turn signal light bulb 1. (See "Tail/brake light bulb" for lens removal and installation procedures. ) 1. Install the tail/brake light lens. 6 6-36 PERIODIC MAINTENANCE AND MINOR REPAIR EAU01008 Troubleshooting Although Yamaha motorcycles receive a thorough inspection before shipment from the factory, trouble may occur during operation. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE YAMAHA NEO-S 50-2002




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual YAMAHA NEO-S 50-2002 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.