User manual YAMAHA MY16-AE

[. . . ] DIGITAL I/O CARD MY16-AE/MY16-AT/MY16-TD Owner’s Manual Bedienungsanleitung Mode d’emploi Manual de instrucciones 取扱説明書 Thank you for purchasing an I/O card for use with Yamaha digital audio equipment. Refer to the respective owner’s manual for installation information. [. . . ] This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. Compliance with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA90620 2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Failure to follow instructions could void your FCC authorization to use this product in the USA. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. [. . . ] Use switch #1 for the CH1–8 connector; switch #3 for the CH9–16 connector. 2/96kHz***) D-sub 25pin x2 MY16-TD* TDIF-1 * ** *** * ** *** * ** *** * ** *** * ** *** If you use the MY16-AE or MY16-TD in Double Channel mode, selecting on the console’s Word Clock Select page a slot that has the card installed enables the console to synchronize to the 88. [. . . ]