User manual YAMAHA MCR-640

[. . . ] G MCR-640 (R-840 + CD-640 + NS-BP300) RECEIVER/CD PLAYER AMPLI-TUNER/LECTEUR CD OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. 1 2 To assure the finest performance, please read this manual carefully. Install this sound system in a well ventilated, cool, dry, clean place and away from direct sunlight, heat sources, vibration, dust, moisture and cold. Top: 30 cm (R-840 Only) Rear: 10 cm Sides: 10 cm Locate this unit away from other electrical appliances, motors, or transformers to avoid humming sounds. [. . . ] €REP” and “A-” light up on the CD player’s front panel display. pROGRAM CLEAR ENTER 2 1 2 BASIC OPERATIONS Press to stop playback. To cancel repeat A-B Press A-B again to make “A-B” disappear from the front panel display. Notes • You cannot set repeat A-B to start in one track and end in another track. € This operation is not available for MP3 or WMA files recorded on a disc/USB device. The CD player enters program input mode and the PROG indicator lights up on the front panel display. CD TRACK PROG Track number Program number 3 Playing back randomly (Random Play) You can play back tracks in the disc/USB device in random order. Note When playing back a disc/USB device with Random Play, the remaining time of the disc/USB device cannot be displayed. Use the numeric keys to enter the track number you want to program and press ENTER. Example: To select the track number 8, press 8, and press ENTER to confirm the entry. The front panel display shows the total number of tracks and then the program screen. 4 To clear the last programmed track RANDOM Press CLEAR during program input mode. To clear all programmed tracks Press CLEAR after exiting program input mode. Note If you open the disc tray or set the CD player to standby mode, the program is automatically cleared. The RANDOM indicator lights up on the CD player’s front panel display and Random Play starts. You can also use the automatic and manual preset tuning features to store up to 30 stations. Automatic tuning Automatic tuning is effective when station signals are strong and there is no interference. Automatic preset tuning Follow the procedure below to preset radio stations automatically. The PRESET indicator starts flashing on the front panel display and automatic station preset starts. € The search starts at the lowest frequency and goes toward the highest frequency. € The receiver automatically applies a preset number to each detected station. D Press and hold TUNING / d for more than 2 seconds to begin automatic tuning. [. . . ] (4) Accidents, lightning, water, fire, improper ventilation, battery leakage or any cause beyond Yamaha’s control. (5) Defects of the system into which this product is incorporated and/or incompatibility with third party products. (6) Use of a product imported into the EEA and/or Switzerland, not by Yamaha, where that product does not conform to the technical or safety standards of the country of use and/or to the standard specification of a product sold by Yamaha in the EEA and/or Switzerland. 5 Where the guarantee differs between the country of purchase and the country of use of the product, the guarantee of the country of use shall apply. [. . . ]