User manual YAMAHA F-15

[. . . ] Be sure to remove the battery if the instrument will not be used for an extended period of time in order to prevent possible damage due to battery leakage. q VOL. is turned to "0" before connecting or disconnecting. e q w u w BATT. (Battery Check) Indicator When battery power is low, the indicator will light. [. . . ] The AMF control r adjusts the center frequency of the band affected by this control. HIGH : Boosts or cuts the level of the high frequencies. SPECIFICATIONS System Pickup SYSTEM-41 (Monaural 2 way) · Yamaha Custom Bar Sensor (Piezo type) Pickup by LR-Baggs · Condenser Mic (with gooseneck) VOL. , MIC. VOL. , MIC TONE, EQ control for bar sensor (piezo) : HIGH, MID, LOW, A. M. F. , PHASE(Phase switch for mic) Combination end pin/power switch 1 k 9V DC, S-006P (6F22) dry cell battery Approx. 120 hours · Hexagonal wrench for neck adjustment x1 · Sound hole cover for preventing feedback x1 · S-006P (6F22) dry cell battery x1 r AMF Control Sets the center frequency of the band of frequencies affected by the MID equalizer control. * This control has no effect when the MID equalizer control is set to its center ("0") position. t MIC. VOL. Controls the volume of the condenser mic that is located inside the body (to the back of the preamplifier). * Setting the volume level too high may result in feedback causing damage to your sound system. control until the feedback stops or use a sound hole cover to prevent feedback. Pre-amplifier Controls Output jack Output impedance Power supply Battery life Accessories y MIC. Rotate the knob to the LOW side to increase emphasis on low frequencies or, to the HIGH side to increase emphasis on high frequencies. u PHASE switch for the MIC Using this switch will change the tone when the mic signal is added to the guitar's tone. It can be effectively used to control feedback depending upon the devices that are used and knob settings. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determined by turning the unit "OFF" and "ON", please try to eliminate the problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to co-axial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA90620 The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries. This device complies with part 15 of the FCC Rules. [. . . ] If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA90620 The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CANADA This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numéique de la classe B est conforme à la norme NMB-003 du Canada. SERVICE / KUNDENDIENST / APRES-VENTE / SERVICIO TÉCNICO / ASSISTENZA TECNICA / If your guitar should need any parts or service, or if you need any information, including the address of your nearest YAMAHA dealer, contact: Für Ersatzteile, Kundendienstfälle oder Informationen jeglicher Art, einschließlich der Adresse des nächsgelegenen YAMAHA-Händlers, wenden Sie sich bitte an: Si vous avez besoin d'une pièce, si la guitare doit être réparée, ou si vous avez besoin d'informations, y compris l'adresse du distributeur YAMAHA le plus proche, adressez-vous à: En caso de requerir alguna pieza o el servicio técnico de la guitarra, así como si necesita alguna información, como pueda ser la dirección del distribuidor YAMAHA que esté más cerca de su casa, póngase en contacto con: Se la vostra chitarra dovesse richiedere parti o assistenza tecnica o se aveste bisogno di qualsiasi informazione, compreso l'indirizzo del più vicino rivenditore autorizzato di prodotti Yamaha, entrare in contatto con: YAMAHA CORPORATION OF AMERICA Guitar Service Department 6600 Orangethorpe Avenue Buena Park, Calif. [. . . ]