User manual YAMAHA DTX522K/DTX542K ASSEMBLY MANUAL

[. . . ] Alternatively, you can place cardboard from the drum kit packaging or the like on the floor to prevent it from being scratched. This is particularly important when using the HH65 Hi-hat Controller and KP65 Kick Pad.  Stopper for PCY100 and PCY135 (x3)  Cable band (x6)  Tuning key (x1)  DTX502 Drum Module (x1)  Power adaptor (x1) * May not be included depending on your particular area. Please check with your Yamaha dealer. Snare pad  Felt pad for PCY135 (x1)  Felt pad for PCY100 (x2)      DTX522K/DTX542K Assembly Manual (this booklet; x1) PCY100/135/155 Owner’s Manual (x1) HH65 Owner’s Manual (x1) XP70/80 Owner’s Manual (x1) KP65 Owner’s Manual (x1)  Module holder (x1)  Module holder screw (x2)  DTX502 Owner’s Manual (x1) Kick pad Hi-hat controller Electronic drum rack Components of DTX522K only  TP70 Tom Pad (x3)  Clamp bolt (for XP80; x1)  Wing bolt (for TP70; x3) Components of DTX542K only  XP70 Tom Pad (x3)  Clamp bolt (for XP70 or XP80; x4)  TP70 Owner’s Manual (x1) Safety Precautions Please read carefully before proceeding. The purpose of the precautions detailed below is to ensure that this electronic drum kit can be used safely without fear of injury or property damage. [. . . ] • Do not use the electronic drum kit’s rack to hold acoustic drums. Doing so could cause clamps to break and the drums to fall off, which in turn could lead to injury. 1. Remove the drum module clamp a and the left leg b from the left side of the rack. 2. Assemble the holder clamp for the hi-hat holder, ensuring that it is oriented as shown in the figure. Following this, reassemble the left leg b and the drum module clamp a. Hi-hat holder Holder clamp NOTICE: Usage Precautions • When connecting and disconnecting cables, be sure to hold the plug and not the cable itself. In addition, avoid placing heavy items on top of cables and do not allow them to touch sharp edges. Failure to avoid these precautions can lead to cable breakage and disconnection. • Do not climb onto the electronic drum kit and avoid placing heavy objects on it. • Avoid using or storing the electronic drum kit in very hot locations (i. e. , in direct sunlight, in close proximity to a heater, or in a closed vehicle) or in highly humid locations (i. e. , in a bathroom or outdoors in wet weather). Failure to observe this precaution can lead to warping, discoloration, malfunction, or breakdown. • Avoid cleaning the electronic drum kit with organic solvents, paint thinner, or alcohol as these substances can cause warping and discoloration. Instead, we recommend you remove dust using a soft dry cloth or wipe clean using a moist, tightly-wrung cloth. If the electronic drum kit is very dirty, first wipe the dirt away using a cloth moistened with a neutral detergent solution and tightly wrung. Following this, wipe away the detergent solution using a cloth soaked in water and tightly wrung. Drum module clamp a Drum module clamp a Left leg b Left leg b * Yamaha Corporation reserves the right to change or modify products or specifications at any time without prior notice. Continued on rear. Assembling the snare and tom pads Tom pads DTX522K: TP70 DTX542K: XP70 Assembling the kick pad 2. Push the snare pad onto the rack’s snare holder. Ensure that the snare holder’s rod is fully inserted into the snare pad’s mounting hole, and then tighten the clamp bolt to secure the pad in place. Snare pad Snare holder Rod  Tom pads 1. 1. As with the snare pad, attach a wing bolt (DTX522K) or clamp bolt (DTX542K) to each of the three tom pads and provisionally tighten (by five or six turns). [. . . ] Lower the pad into place with the cymbal holder’s shaft passing through the central hole. When mounted, the stopper’s pin should rest inside the pad’s smaller hole. * If you were to play your cymbal or hi-hat pad without the stopper’s pin positioned well inside the smaller hole, the pad could rotate, causing the cable to be pulled out. It is very important, therefore, to ensure that the stopper is secured as shown in Step 5 above. L plugs SNARE TOM1 TOM2 TOM3 RIDE CRASH KICK HI HAT HH CON 3. [. . . ]