User manual YAMAHA CD-C600

[. . . ] Printed in Malaysia WS19280 CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. 1 To assure the finest performance, please read this manual carefully. 2 Install this sound system in a well ventilated, cool, dry, clean place – away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. 5 cm (1 inch) 3 Locate this unit away from other electrical appliances, motors, or transformers to avoid humming sounds. [. . . ] Note To play back an 8 cm (3 inch) CD, place it in the inner recessed area of the disc tray. Press MODE to select a desired disc play mode (1DISC or 5DISC) confirming it on the display. Press (Play) to start playback from the first track or file of disc 1. (If necessary) Select a desired disc by using DISC SKIP / , or a DISC (1-5) button on the front panel. PLAYXCHANGE PLAYXCHANGE is a function that allows you to replace discs during disc playback without interrupting it. Press the PLAYXCHANGE button on the front panel to open the disc tray and replace discs. CAUTION Never try to load a disc in the position marked x in the figure below. This may cause damage to the unit and the disc, because that is where the disc being played back is located. 4 5 Program playback Audio CD In the program playback mode, you can play back tracks in a programmed sequence. Notes • You can program and play back tracks in any order from all of the loaded discs (1-5). € The programmed tracks are erased when the disc is ejected, this unit is turned off, or this unit is turned to the standby mode. 8 En PLAYING BACK iPod/USB DEVICE Connecting iPod/USB devices Notes iPod • Use the USB cable supplied with your iPod. OPERATION 1 4 Connect your USB device or iPod via USB cable Playing back iPod 1 Press CD/USB to select the iPod/USB mode. The iPod/USB indicator on the front panel lights up in orange, then changes to green when playback is ready. Operate your iPod to start playback, select a track, pause, and stop playback. Playing back USB devices 1 2 Press CD/USB to select the iPod/USB mode. Filename is displayed in the front panel display and playback starts automatically in order by date and time of creation if playable files are in the USB device. Press FOLDER / on the remote control to select a folder, and then press b/a or numeric buttons to select a track. 2 y You can also use the following buttons: p (Playback), e (Pause), s (Stop), b (Skip backward), a (Skip forward), w (Search backward), and f (Search forward) on this unit or Remote Control. 3 Note iPod may not function properly with this unit if software on iPod is not updated. English 9 En PLAYING BACK iPod/USB DEVICE Disconnecting iPod/USB devices Stop playback, and then disconnect your iPod or USB device. It is recommended that you press CD/USB to switch to the CD mode, confirm that the CD/USB indicator goes off, and then disconnect your iPod/USB device. [. . . ] The original invoice or sales receipt (showing date of purchase, product code and dealer’s name) MUST accompany the defective product, along with a statement detailing the fault. In the absence of this clear proof of purchase, Yamaha reserves the right to refuse to provide free of charge service and the product may be returned at the customer’s expense. The product MUST have been purchased from an AUTHORISED Yamaha dealer within the European Economic Area (EEA) or Switzerland. The product must not have been the subject of any modifications or alterations, unless authorised in writing by Yamaha. [. . . ]