User manual YAMAHA AX-330

[. . . ] Verificare che tutte le parti seguenti siano contenute nell'imballaggio dell'apparecchio. Desembale el aparato y verifique que los siguientes accesorios están en la caja. Controleer na het uitpakken of de volgende onderdelen voorhanden zijn. STANDBY/ON DECK A/B TAPE DIR A DIR B DISC SKIP CD ­ PRESET + A/B/C/D/E TUNER MD TAPE CD/DVD AUX PHONO TUNER q q q q q q q Batteries (size AA, R6, UM-3) Piles (format AA, R6, UM-3) Batterien (Größe AA, R6, UM-3) Batterier (Storl. AA, R6, UM-3) Batterie (dimensioni AA, o R6, o UM-3) Pilas (tamaño AA, tipo R6, UM-3) Batterijen (maat AA, R6, UM-3) ­ VOLUME + Opening and closing the front cover Close the front cover whenever the controls inside the panel are not used. Ouverture et fermeture du couvercle avant Fermer le couvercle avant lorsque les commandes placées à l'intérieur du panneau ne sont pas utilisées. Öffnen und Schließen der Reglerfachklappe Schließen Sie die Reglerfachklappe, wenn Sie die Regler im Fach nicht verwenden. Öppning och stängning av frontluckan Ha frontluckan stängd när kontrollerna innanför den inte används. Apertura e chiusura dello sportello anteriore Richiudere sempre lo sportello anteriore quando i comandi non vengono utilizzati. Apertura y cierre de la cubierta delantera Cierre la cubierta delantera cuando no utilice los controles del panel. Openen en sluiten van het voorklepje Sluit het voorklepje steeds wanneer de bedieningsorganen binnen in het paneel niet gebruikt worden. [. . . ] Simply insert the Banana Plug connector into the corresponding terminal. 2 1 3 1 Loosen the knob. 10 mm (3/8") insulation from the speaker wires. ] 3 Tighten the knob and secure the wire. Rear panel parts IMPEDANCE SELECTOR switch * 1 AC OUTLET(S) (SWITCHED) WARNING Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged. If this unit fails to turn on when the POWER switch is pressed: The IMPEDANCE SELECTOR switch may not be set to either end. If so, set the switch to either end when this unit's power supply is completely cut off. Select the position whose requirements your speaker system meets. A OR B : 6MIN. /SPEAKER (Europe, China and General models) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 SWITCHED OUTLET Use these to connect the power cords of your components to this unit. The power to the SWITCHED outlets is controlled by this unit's POWER or STANDBY/ON switch. These outlets will supply power to any connected unit whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLETS is 100W. 3 * 2 A OR B : 4MIN. /SPEAKER GND terminal (For turntable use) (Right position) If you use one pair of speakers, the impedance of each speaker must be 4 or higher. * Pressing DIR A will reverse the tape direction on a single cassette tape deck with the automatic reverse function. PRESET ­: Press this key to select the previous preset station number. A/B/C/D/E: Press this key to select the group (A ­ E) of preset station numbers. 2 3 E-8 English OPERATION Playing a source STANDBY 5848 AUX MD TAPE CD/DVD TUNER PHONO AX-496 PURE DIRECT AX-330 TAPE MONITOR 2 3 STANDBY CD/DVD DIRECT AMP POWER ON OFF INPUT VOLUME l6 20 l2 PHONES SPEAKERS A B 2 3 ON OFF 4 BASS l 0 l 2 3 4 5 5 2 3 TREBLE l 0 l 2 3 4 5 5 BALANCE l 2 3 4 L5 0 l 2 3 4 5R LOUDNESS l 2 3 4 5 6 7 FLAT --30dB I0 9 8 REC OUT TAPE MD AUX CD/DVD 28 TUNER PHONO 8 STANDBY/ON 40 4 4 60 2 0 ­dB 8 1, 7 4 1 40 l6 20 l2 28 8 5 4 Select speakers A or B. SPEAKERS A B 60 2 0 ­dB ON OFF Set to the "" position. 2 Press POWER inward (ON). STANDBY POWER ON OFF * Both speakers A and B can be selected. * Be sure that the IMPEDANCE SELECTOR switch is correctly set as explained on page 5. * If you listen with headphones, press both switches to release them outward (OFF). 6 3 If the STANDBY indicator is illuminated, press STANDBY/ON to turn on the power. (The STANDBY indicator turns off. ) STANDBY/ON Play the source. 7 l6 20 l2 28 8 ­ 4 ­ + VOLUME + STANDBY/ON ­ + 40 60 2 0 ­dB Adjust the output level. STANDBY Turns off. 8 POWER Adjust the tonal quality by using the BASS, TREBLE, BALANCE, LOUDNESS controls or the CD/DVD DIRECT AMP switch (or PURE DIRECT switch for AX-496 only). AX-330 only MD TAPE CD/DVD AUX ­ + PHONO TUNER If the TAPE MONITOR indicator is illuminated when you listen to a source, press TAPE MONITOR to turn off the TAPE MONITOR indicator. When you finish using this unit Press STANDBY/ON again to set this unit in the standby mode. (The STANDBY indicator lights up. ) AUX MD TAPE CD/DVD TUNER PHONO To completely cut off this unit's power supply from the AC line The indicator of the selected source lights up. Press POWER to release it outward (OFF). E-9 Recording a source to tape (or MD) AX-496 STANDBY 3, 5, 6 AUX MD TAPE CD/DVD TUNER PHONO PURE DIRECT CD/DVD DIRECT AMP POWER ON OFF INPUT VOLUME l6 20 l2 PHONES SPEAKERS A B 2 3 ON OFF 4 BASS l 0 l 2 3 4 5 5 2 3 TREBLE l 0 l 2 3 4 5 5 BALANCE l 2 3 4 L5 0 l 2 3 4 5R LOUDNESS l 2 3 4 5 6 7 FLAT --30dB I0 9 8 REC OUT TAPE MD AUX CD/DVD 28 TUNER PHONO 8 STANDBY/ON 40 4 4 60 2 0 ­dB 1 1 Select the source you want to record. REC OUT TAPE MD AUX CD/DVD TUNER PHONO 3 Begin recording on the tape deck (or MD recorder). 4 5 The sound of the recording can be monitored by selecting the tape deck (or MD recorder) with the INPUT selector. 2 3 MD TAPE CD/DVD Play the source. AUX ­ + PHONO TUNER Select the source with the INPUT selector and adjust VOLUME to check the sound output. MD TAPE CD/DVD 6 Listening to another source by selecting it with the INPUT selector will not affect the recording. AUX ­ + PHONO TUNER l6 20 l2 28 8 ­ 4 ­ + VOLUME + 40 60 2 0 ­dB E-10 English AX-330 STANDBY 1 AUX MD TAPE CD/DVD TUNER PHONO POWER ON OFF 4 TAPE MONITOR CD/DVD DIRECT AMP INPUT VOLUME l6 20 l2 PHONES SPEAKERS A B 2 3 ON OFF 4 BASS l 0 l 2 3 4 5 5 2 3 TREBLE l 0 l 2 3 4 5 5 BALANCE l 2 3 4 L5 0 l 2 3 4 5R LOUDNESS l 2 3 4 5 6 7 FLAT --30dB I0 9 8 REC OUT TAPE MD AUX CD 28 TUNER PHONO 8 STANDBY/ON 40 4 4 60 2 0 ­dB 1 1 Select the source you want to record. 2 3 TAPE CD/DVD Begin recording on the tape deck (or MD recorder). MD 4 AUX ­ + PHONO TUNER If the tape deck is used for recording, you can monitor the sound of recording. To monitor the sound of recording, light up the TAPE MONITOR indicator by pressing TAPE MONITOR. TAPE MONITOR AUX MD TAPE CD/DVD TUNER PHONO 2 Play the source and then turn VOLUME up to check the sound output. l6 20 l2 Note Turn off the TAPE MONITOR indicator when the recording is finished by pressing TAPE MONITOR. 28 8 ­ 4 ­ + VOLUME + 40 60 2 0 ­dB Notes on recording The VOLUME, BASS, TREBLE, BALANCE, LOUDNESS controls and CD/DVD DIRECT AMP switch (and PURE DIRECT switch for AX-496 only) have no effect on the material being recorded. Please check the copyright laws in your country to record from records, compact discs, radio, etc. [. . . ] 10 dB (20 Hz) TREBLE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 dB (20 kHz) Continuous LOUDNESS Control Attenuation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ­30 dB (1 kHz) <AX-496> 8/6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 130/150W <AX-330> 6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]