User manual YAMAHA A-760 service manual

[. . . ] FOR CANADIAN CUSTOMERS To prevent electric shock, match wide blade of plug to wide slot and fully insert. This Class B digital apparatus complies with Canadian ICES-003. 13 14 Read these instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] and Europe models) First, tighten the knob and then insert the banana plug into the end of the corresponding terminal. Note When making bi-wire connections, remove the shorting bridges or cables on the speaker. Banana plug y To use the bi-wire connections, switch the SPEAKERS selector to the A+B position. Note One or two speaker sets can be connected to this unit. English 7 En CONNECTIONS Connecting the supplied power cable To the wall outlet with the supplied power cable (Asia and General models) VOLTAGE SELECTOR (Asia and General models only) The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local main voltage BEFORE plugging the supplied power cable into the wall outlet. Improper setting of the VOLTAGE SELECTOR may cause damage to this unit and create a potential fire hazard. Rotate the VOLTAGE SELECTOR clockwise or counterclockwise to the correct position using a straight slot screwdriver. AC 220/230­240 V, 50/60 Hz General model . . . . . . AC 110/120/220/230­240 V, 50/60 Hz AC OUTLET(S) (SWITCHED) U. K. 1 outlet Korea model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . None Other models . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 outlets Use these outlets to connect the power cables from your other components to this unit. The power to the AC OUTLET(S) is controlled by POWER on the front panel of this unit (or on the remote control). The outlet(s) supply power to any connected component whenever the power of this unit is turned on. For information on the maximum power (total power consumption of components), see "SPECIFICATIONS" on page 15. Note Do not connect components with a built-in amplifier, such as a subwoofer, etc. Connecting the supplied power cable Plug the supplied power cable into the AC IN on the rear panel of this unit and then, plug the power cable into the wall outlet after all other connections are complete. 8 En OPERATION PLAYING AND RECORDING Playing a source 3 Rotate the INPUT selector on the front panel (or press one of the input selector buttons on the remote control) to select the input source you want to listen to. The POWER on indicator also does not light up. Possible Causes The supplied power cable is not connected or the cable is not completely inserted. The POWER ( ) button is pressed on the remote control while this unit is turned off. There is a problem with the internal circuitries of this unit. Solutions Connect the supplied power cable firmly. Press POWER on the front panel to ON. Refer to page 8 3 Disconnect the AC power cable and contact the nearest authorized Yamaha dealer or service center. If an unusual odor or noise is generated from the unit, do not turn on the power, disconnect the AC power cable, and contact a service center for repair. Connect the speaker cables properly and press the power button ON again. The VOLUME is decreased automatically and this unit is turned on after the INPUT indicator blinks for about 15 seconds. Confirm normal sound output from speakers by increasing the volume gradually, then you can operate this unit normally. The VOLUME is decreased automatically and this unit is turned on after the INPUT indicator blinks for about 15 seconds. Confirm normal sound output from speakers by increasing the volume gradually, then you can operate this unit normally. Rotate the VOLUME control on the front panel to decrease the volume level and then turn the power on again. [. . . ] Si vous rencontrez la moindre difficulté, n'hésitez pas à contacter directement Yamaha dans votre pays de résidence. Vous pouvez trouver toutes informations complémentaires sur notre site Web (http://www. yamaha-hifi. com/ ou http://www. yamaha-uk. com/ pour les résidents au Royaume-Uni). Yamaha garantit votre produit contre tout défaut de fabrication, pièces et main d'oeuvre, pour une durée de 2 ans à compter de la première date de vente au détail. Yamaha s'engage, dans les conditions décrites ci-après, à procéder à la réparation du produit défectueux (ou d'un quelconque de ses composants) ou à son remplacement à l'appréciation de Yamaha en prenant à sa charge les coûts relatifs aux pièces détachées et à la main d'oeuvre. [. . . ]