User manual YAMAHA 25NEMO SERVICE MANUAL

[. . . ] For a full understanding of its functions and to obtain maximum use and long life from the product, please read this Owner's Manual thoroughly before use. CHH-920 Closed Hi-Hat Holder r Open Clamp To adjust the angle of the entire closed hi-hat holder, loosen the wing nut (A) on the tilter. [. . . ] Make sure that the clamp's sections are parallel then tighten both nuts firmly. q Cymbal Support Plate To attach the bottom hi-hat cymbal, first remove the hi-hat clutch, wing nut and felt. Next, confirm that the metal plate and rubber washer are on the cymbal support plate and set the bottom hi-hat cymbal, felt (small) and wing nut on the holder in that order. The angle of the cymbal can be adjusted by rotating the knurled-head bolt, located under the support plate, then securing the bolt in place with the fixing nut. t Mounting Pipe The 22. 2 mm diameter mounting pipe for the hi-hat holder makes possible a wide variety of set-ups. Once the desired sound has been obtained, firmly tighten the lock nuts onto each other. y Position Clamp Once the closed hi-hat holder set-up has been decided, the position clamp on the mounting pipe can be used to mark the settings for future set ups and to prevent unintentional changes during musical performances. Note: To maintain smooth action, occasionally apply some grease-grade oil to all of the moving parts. e Cymbal Position The large spring tension dial is used to adjust the span between the cymbals. Rotate the dial to the right to close, or to the left to open the span between the cymbals. [. . . ] Rotate the dial to the right to close, or to the left to open the span between the cymbals. [. . . ]