User manual YAMAHA 02RV2

[. . . ] This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Failure to follow instructions could void your FCC authorization to use this product in the USA. [. . . ] Use the CURSOR buttons to select the RECALL icon and rotate the encoder wheel to select a dynamics program . Use the CURSOR buttons to select the STORE icon and select a dynamics program with the encoder wheel. The dynamics program is stored. The top of the page shows the dynamics LIB icon, the main control prompts, the dynamics graph, and the gain reduction meter plus a level meter for the currently selected channel pair. When the cursor is on the STORE, RECALL, CLEAR, COPY, or PASTE icons, the encoder wheel is used to scroll through the program list. A small diagram of the dynamics graph of the highlighted program is shown to the right along with its vital statistics, such as Attack, Hold, Decay, and so forth. The CURSOR buttons are used to select the character, and the encoder wheel is used to change its value. Use the CURSOR buttons to select from the STORE, RECALL, CLEAR, COPY, PASTE, INS. , and DEL. icons. Exiting the Library Selecting the LIB icon and pressing the [ENTER] button switches back to the DYNAMICS 1/2 page. You can also use the [DYNAMICS] button. 02R User's Guide 88 Dynamics Icons · STORE --This icon is used to store the current program to the library. Use the encoder wheel to select a program and press the [ENTER] button. The 02R displays a confirmation dialog box asking if you want to store your settings in the selected program. The dialog box has two icons: "CANCEL" and "EXECUTE". Note: You can customize your 02R to prevent the confirmation dialog box appearing during the STORE operation. See "Preferences" on page 198 of the User's Guide for more information. To cancel the STORE operation, either press the [ENTER] button or wait about 10 seconds--the STORE operation will be automatically cancelled. To store your settings, use the CURSOR buttons to select the "EXECUTE" icon and press the [ENTER] button. When you confirm a STORE operation, any existing data in the selected program location is overwritten. YOU SHOULD ALWAYS BE CAREFUL WHEN THE 02R DISPLAYS A CONFIRMATION DIALOG BOX!· RECALL--This icon is used to recall a program from the library. Use the encoder wheel to select a program and press the [ENTER] button. Use the encoder wheel to select a dynamics program and press the [ENTER] button. The 02R displays a confirmation dialog box asking if you want to clear the dynamics program. [. . . ] Settings that are not stored consist mainly of monitor controls, analog controls, and switches. Shelving--An EQ circuit that is used to cut and boost a signal above or below a specified frequency. Signal to Noise ratio (S/N)--The difference between the nominal signal level and the residual noise floor, usually expressed in decibels. System Exclusive--A MIDI message that is used to transmit data between MIDI devices that is exclusive to those devices. [. . . ]