User manual YAMAHA 02R96-VCM EXTRA EFFECT TYPE LIST

[. . . ] Failure to follow instructions could void your FCC authorization to use this product in the USA. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. [. . . ] You can stop the Title Edit window from appearing by turning off the Store Confirmation preference on page 197. CLEAR: To delete the contents and title of the selected memory, select this and press [ENTER]. Read-only preset memories have an "R" icon next to their name. Empty memories have the title "No Data!" Memory #0 is a read-only memory that you can recall to reset settings to their initial values. Memory #U is a special read-only memory that allows you to undo and redo memory recall and store operations. After recalling a memory, you can revert to the previously recalled memory by recalling memory #U. After storing a memory, you can revert it to its previous contents by recalling memory #U. You can redo either of these undo operations by recalling memory #U again. 3 02R96-VCM-VCM--Owner's Manual Channel Library 123 Channel Library 1 Input Channel, Bus Out, Aux Send, and Stereo Out channel settings can be stored in the Channel library, which contains 2 preset memories and 127 user memories. Use the DISPLAY ACCESS [VIEW] button to select the Channel Library page. 2 Use the LAYER buttons to select Layers, and the [SEL] buttons to select channels. When storing, the settings of the currently selected channel are stored to the selected memory. When recalling, the settings in the selected memory are applied to the currently selected channel. CURRENT CONFIGURATION: Bus Out pairing information for the current configuration is displayed here. LIBRARY CONFIGURATION: Bus Out pairing information for the configuration stored in the currently selected memory is displayed here. Only memories whose Bus Out pairing configuration matches the current configuration can be recalled. When the current configuration and the selected memory don't match, the word "CONFLICT" appear in the LIBRARY CONFIGURATION box. For details on the Store, Recall, Title Edit, and Clear functions, see "General Library Operation" on page 122. 02R96-VCM-VCM--Owner's Manual Gate Library 127 Gate Library 1 Input Channel Gate settings can be stored in the Gate library, which contains 4 preset memories and 124 user memories. Use the DYNAMICS [DISPLAY] button to select the Gate Library page. 2 Use the LAYER buttons to select the Layers, and the [SEL] buttons to select Input Channels. When storing, the Gate settings of the currently selected Input Channel, indicated in the upper-right corner, are stored to the selected memory. When recalling, the Gate settings in the selected memory are applied to the currently selected Input Channel. CURRENT TYPE: This indicates the current Gate type of the currently selected channel. CURRENT CURVE: This is the Gate curve of the currently selected channel. GR meters: These meters indicate the amount of gain reduction being applied by the Gate, and the levels of the currently selected channel and its adjacent channel. [. . . ] It works in unison with the PRE EQ, PRE FADER, and POST FADER buttons for Output Channels on the Meter pages. The indicators show the current setting. 2 6 F Meters These 12-segment LED meters display the signals levels of the channels on the currently selected Layer. G STEREO meters These 32-segment meters display the signal levels of the Stereo Out. 1 H CONTROL ROOM button This button is used to display the level of the Control Room signal on the STEREO meters. Its indicator lights up when the STEREO meters are displaying Control Room levels. [. . . ]