User manual XINDAK PA-1

[. . . ] Above an empty cabinet or a drawer A space of at least 40 mm, or an opening of 5 mm on the width measurement of the cabinet, should be created. 40mm Opening of at least 5 mm on the overall width measurement of the surface. 40 SUPPORTING SURFACE 11 GB The thickness of the supporting surface should be taken into account when choosing screws for the fixing hooks: • 30 mm thick: 17. 55 mm screws Separate the wires and connect them in accordance with the instructions given in the following table and diagrams: Voltage and mains frequency 400V - 2+N ~ 50 Hz 230V 3 ~ 50Hz Electrical cable Wire connection : yellow/green; N: the two blue wires together L1: black L2: brown : yellow/green; N1: blue 400V - 2+2N ~ 50 Hz N2: blue L1: black L2: brown Fix the hob as follows: 1. [. . . ] • CONTROL PANEL LOCK button prevents accidental changes to the hob settings (see Startup and use). • CONTROLS LOCKED indicator light shows the control panel has been locked (see Start-up and use). • COOKING ZONE SELECTOR button shows a particular cooking zone has been selected and therefore various adjustments are possible. • COOKING ZONE SELECTOR button is used to select the required cooking zone. • POWER indicator provides a visual display for the current heat level. • INCREASE POWER button switches on the hotplate and controls the power (see Start-up and use). • REDUCE POWER button controls the power and switches off the hotplate (see Start-up and use). 0 kW indicator light signals that the absorbed power value falls between 1. 5 kW indicator light signals that the absorbed power value is less than 1. 13 Start-up and use GB  The glue applied on the gaskets leaves traces of grease on the glass. Before using the appliance, we recommend you remove these with a special nonabrasive cleaning product. When the temperature has reached an appropriate level, this message disappears and the hob may be used again. Safety switch The appliance has a safety switch that automatically switches off the cooking zones when they have been in operation for a certain amount of time at a given power level. For example: the right rear hotplate is set to 5 and will switch off after 3 hours of continuous operation, while the front left hotplate is set to 2 and will switch off after 10 hours. Power level 1 2 3-4-5 6 7-8 9-10 11 Operating time limit in hours 10 6 5 4 3 2 1 GB * Cast iron Enamelled steel Special stainless steel Copper, Aluminium, Glass, Earthenware, Ceramic, non magnetic Stainless steel In addition, to obtain the best results from your hob: • Use pans with a thick, flat base to fully utilise the cooking zone. • Always use pans with a diameter that is large enough to cover the hotplate fully, in order to use all the available heat. • Make sure that the base of the cookware is always dry and clean, to fully utilise and extend the life of both the cooking zones and cookware. • Avoid using the same cookware that has been used on gas burners: the heat concentration on gas burners may distort the base of the pan, causing it not to adhere correctly. 15 GB Buzzer This can also indicate several irregularities: • An object (a pan, cutlery, etc. To unlock it press the button, the settings will have been maintained. If the cause of the problem is not removed, the buzzer will keep sounding and the hob will switch off. 16 Precautions and tips  This appliance has been designed and manufactured in compliance with international safety standards. [. . . ] Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. After cleaning, it is advisable to rinse the surface well and dry it thoroughly.  Some hobs have an aluminium frame which is Cleaning the appliance Do not use abrasive or corrosive detergents (for example, products in spray cans for cleaning barbecues and ovens), stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface beyond repair. Do not use any cleaning or degreasing products which are not suitable for use with aluminium. [. . . ]