User manual XINDAK MUSE DELUXE 1.0

[. . . ] The appliance must be installed by a qualified professional in accordance with the instructions provided. Incorrect installation may damage property or cause harm to people or animals. • At a minimum distance of 40 mm from the back panel or any other vertical surfaces. • So that a minimum distance of 10 mm is maintained between the installation cavity and the cabinet underneath. [. . . ] • COOKING ZONE PROGRAMMED indicator lights show which cooking zones are being used during a cooking programme (see Start-up and use). • CONTROL PANEL LOCK button prevents accidental changes to the hob settings (see Startup and use). • CONTROL PANEL LOCK indicator light shows the control panel has been locked (see Start-up and use). 17 GB Extendable cooking zones Certain models are fitted with extendable cooking zones. These may be circular or oval and vary in their extensibility (they may be double or triple hotplates). A list of controls is given below (these controls are only present in models with the extendable cooking zone option). circular extendable hotplate Oval extendable hotplate DOUBLE HOTPLATE ON indicator light TRIPLE HOTPLATE ON indicator light DOUBLE HOTPLATE ON indicator light DOUBLE HOTPLATE ON button TRIPLE HOTPLATE ON button DOUBLE HOTPLATE ON button • DOUBLE HOTPLATE ON button switches on the double hotplate (see Start-up and use). • DOUBLE HOTPLATE ON indicator light shows the double hotplate has been switched on. TRIPLE HOTPLATE ON button switches on the triple hotplate (see Start-up and use). • TRIPLE HOTPLATE ON indicator light shows the triple hotplate has been switched on. The glue applied on the gaskets leaves traces of grease on the glass. The lights corresponding to the other hotplates programmed will flash. To display the time remaining for the other programmed hotplates, press the button repeatedly. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Press the button repeatedly until the time you wish to change is shown. Confirm by pressing the To cancel a programme, follow the above instructions. The setting will return to zero and the display will no longer be operating in the programme setting mode. “Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with the control panel lock activated. • Press the button for the rear left hotplate, the button for the front right hotplate and the button simultaneously and hold them for three seconds. • The display will alternate between DE and MO and the hob will be switched off. • When the hob is switched on again it will be set to the “demo” mode. [. . . ] • Remember that the cooking zones remain relatively hot for at least thirty minutes after they have been switched off. An indicator light provides a warning when residual heat is present (see Start-up and use). • Keep any object which could melt away from the hob, for example plastic and aluminium objects, or products with a high sugar content. Be especially careful when using plastic film and aluminium foil or packaging: if placed on surfaces that are still hot, they may cause serious damage to the hob. [. . . ]