User manual X-TREME X-360

[. . . ] Inspect your scooter thoroughly before each use for loose or missing parts. Avoid unintentional starts by turning the scooter off while not in use. To avoid the risk of a short circuit in the electrical parts, do not use your X-Treme Electric scooter in the rain and never spray or wash off your scooter with water. To avoid damage to the battery, do not use the charger if it has been damaged in any way. [. . . ] Note the master kill switch must be in the on position for the scooter to accept a charge. Open the charging socket cover located on the left side of the scooter body. 5) Find the charger socket end that has a three-prong socket and plug it into the scooter. When first plugged in, the charger has two red lights that will illuminate at the same time, indicating that the charging process has started. Once the light on the charger turns green, you may remove the charger and close the safety cap. Fig. 5 Riding Make sure that all of the exposed bolts and screws are tightened. You can control the speed of your scooter by the amount of pressure you use when rotating the hand throttle. 4. Stopping/Braking To brake, release the THROTTLE GRIP and depress the BRAKE LEVER on the left side of the handlebar. When the unit feels like it is loosing power or not accelerating to full speed, the scooter is ready to be re-charged. BRAKING SYSTEM The X-360 uses a hub brake system on the rear wheel of the scooter activated by a hand brake lever on the left side of the handlebar. Squeezing the hand brake lever with your left hand activates the rear brake. Practice braking on a smooth, dry surface to get used to the feel of the braking system. Braking distance is affected by wet conditions and loose and uneven riding surfaces. Adjusting the Brakes The Brakes on the X-360 should come fully adjusted from the factory. However, it may be necessary to adjust the brakes from time to time. To adjust the rear brakes:: For brakes that are adjusted too tight: 1. Loosen the tension screw on the left hand brake lever by rotating it counter-clockwise until the wheel spins freely. Tighten the tension screw on the left hand brake lever by rotating it clockwise until the wheel has a slight drag. 6 For further adjustment, Locate the adjustment screw on the rear brake hub located on the rear wheel. Loosen the tension screw on the rear brake hub by rotating it clockwise until the wheel spins freely. Tighten the tension screw on the rear brake hub by rotating it counter-clockwise until the wheel has a slight drag. 7 Page9 Squeaky Brakes The brakes may squeak before they are broken in. This is normal and will not affect the function or performance of the brakes. [. . . ] If any battery should become faulty within 6 months from the purchase date, the manufacturer will replace the battery free of charge. The manufacturer may require that old batteries be returned to for exchange. X-Treme Electric Scooters Manufacturers & Wholesale Distributors is not responsible for the proper or improper use of merchandise sold. We care about our customers and urge you to exercise caution and take necessary safety measures to protect yourself while engaging in cycling. [. . . ]