User manual WHIRLPOOL WOD51EC0AB WARRANTY INFORMATION

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL WOD51EC0AB. We hope that this WHIRLPOOL WOD51EC0AB user guide will be useful to you.


WHIRLPOOL WOD51EC0AB WARRANTY INFORMATION: Download the complete user guide (91 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL WOD51EC0AB DIMENSION GUIDE (439 ko)
   WHIRLPOOL WOD51EC0AB USE & CARE GUIDE (1410 ko)
   WHIRLPOOL WOD51EC0AB INSTALLATION GUIDE (12578 ko)

Manual abstract: user guide WHIRLPOOL WOD51EC0ABWARRANTY INFORMATION

Detailed instructions for use are in the User's Guide.

[. . . ] • During installation make sure that the sides of the oven do not touch the adjacent units. • If the kitchen unit is not securely fixed to the wall, it must be anchored with standard brackets (G) available on the market, see fig. 4. 1 2 3 4 16 Hob Attention: to install the hob on other surfaces than wood (e. g. plastic, ceramic, marble, stone, etc. ) remember to ask After Sales Service for the fixing plates (Fig. [. . . ] • The oven power cable must be long enough to connect the built-in appliance to the mains. • Observance of safety directives requires that a multi-pole switch with a minimum contact gap of 3mm be used for the installation. • After the oven has been installed, the electrical components must be inaccessible. Connecting the oven to the power supply • Make sure that the voltage indicated on the rating plate is the same as the mains voltage. The rating plate is on the front edge of the oven (visible when the door is open). Remove the two fastening screws of the terminal box cover located on the bottom part of the oven's rear covering. Remove the cover to gain access to the terminal box and insert the power cable (see table) through the opening located on the bottom of the oven. Connect the cable to the terminal box, tighten the screws as far as they will go and secure it to the cable fastener. Put the cover back on by inserting the two blades in the slots and fasten it with the two screws. Power supply cable table N° of conductors Type of cable 1N+ 2 + 2N+ 3N+ 3 + ~ ~ ~ ~ ~ H05 RR-F 3 X 4 mm² H05 RR-F 3 X 4 mm² H05 RR-F 4 X 2. 5 mm² H05 RR-F 5 X 1. 5 mm² H05 RR-F 4 X 2. 5 mm² 19 IMPORTANT: do not connect the oven to the power supply before you have finished connecting the oven and hob. • Before connecting the oven to the power supply, make sure that the hob is among the ones listed in the hob/oven pairing product sheet provided. 10) to the oven connectors (D), making sure that you match the colours and that the connector slots are aligned. • Do not put heavy objects on the door because they could damage the oven cavity and hinges. • Do not cover the bottom of the oven with aluminium foil or other objects. • Do not pour water directly into the inside of a hot oven. • Fruit juice drippings from the baking tray may leave permanent stains. • Never drag pots and pans across the bottom of the oven to prevent the coating from being scratched. • Residual condensation after cooking could damage the oven and surrounding kitchen units in time. We recommend that you: - set the lowest temperature; - cover food; - remove food from the oven; - dry the wet parts when the oven is cool. • The front panel and the handle of the oven door warm up when the appliance is switched on for a long time at high temperatures. • Never touch the oven with any wet part of the body and do not operate it with bare feet. • Do not pull the appliance or the power supply cable to disconnect them from the electrical supply. 21 • Do not allow children to touch: - the oven and its controls, especially when in operation and immediately afterwards to avoid injury; - packaging (bags, polystyrene, metal parts, etc. ); - an oven to be scrapped. • Make sure that the electrical cables of other appliances used near the oven do not touch hot parts and are not trapped in the oven door. [. . . ] - If the electronic programmer (depending on the model) presents the message “F XX”, contact the nearest After Sales Service. Specify in this case the number that follows the letter “F”. AFTER SALES SERVICE Before you call the After Sales Service: 1. Try to solve the problem yourself following the points described in “Troubleshooting Guide”. Turn the appliance off and on again, to make sure that the problem has been solved. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL WOD51EC0AB




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL WOD51EC0AB will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.