User manual WHIRLPOOL WFW86HEBW INSTALLATION GUIDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL WFW86HEBW. We hope that this WHIRLPOOL WFW86HEBW user guide will be useful to you.


WHIRLPOOL WFW86HEBW INSTALLATION GUIDE: Download the complete user guide (4216 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL WFW86HEBW (6111 ko)
   WHIRLPOOL WFW86HEBW (6111 ko)
   WHIRLPOOL WFW86HEBW DIMENSION GUIDE (584 ko)

Manual abstract: user guide WHIRLPOOL WFW86HEBWINSTALLATION GUIDE

Detailed instructions for use are in the User's Guide.

[. . . ] N A level floor with maximum slope of 1" (25 mm) under entire washer. Installing on carpet or surfaces with foam backing is not recommended. N Floor must support washer’s total weight (with water and load) of 315 lbs (143 kgs). [. . . ] N If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. N Check with a qualified electrician if you are not sure the washer is properly grounded. 2 m) It is necessary to remove all shipping materials for proper operation and to avoid excessive noise from washer. Place power cord over top Loosen bolts with a 1/2" (13 mm) wrench. Cover bolt holes with transport  bolt hole plugs Remove the yellow shipping strap from the cord. Gently place power cord over top of washer to allow free access to back of washer. IMPORTANT: Do not plug washer in until installation has been completed. Attach drain hose to drain port Ribs Close bolt holes on cabinet back with four transport bolt hole plugs included with washer parts. Remove power cord If clamp is not already in place on elbow end of drain hose, squeeze clamp with pliers and slide it over end of hose, centering it between the ribs, as shown. Squeeze clamp with pliers and slide elbow end of drain hose onto drain port and secure with clamp. For a floor drain, remove the preinstalled drain hose form as shown in Step 8. Pull power cord through opening in rear panel and close hole with attached cap. NOTE: If washer is transported at later date, call your local service center to avoid suspension and structural damage, a certified technician must properly set up washer for relocation. Washer IMPORTANT: To avoid leaks, check that your water inlet hoses have flat washers at both ends. Washer must be connected to water faucets with new inlet hoses with flat washers (not provided). For floor drain installations, you will need to remove the drain hose form from the end of the drain hose. [. . . ] When washer is level and all four feet are firmly in contact with the floor, use a 9/16" or 14 mm open-end or adjustable wrench to turn jam nuts counterclockwise on leveling feet tightly against washer cabinet. Q Check that transport materials were completely removed from back of washer. Q Check that both hot and cold hoses are attached and water q Check for leaks around faucets, valves, and inlet hoses. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL WFW86HEBW




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL WFW86HEBW will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.