User manual WHIRLPOOL MFW 1312AGW INSTRUCTION FOR USE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL MFW 1312AGW. We hope that this WHIRLPOOL MFW 1312AGW user guide will be useful to you.


WHIRLPOOL MFW 1312AGW INSTRUCTION FOR USE: Download the complete user guide (966 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL MFW 1312AGW MODE D'EMPLOI (850 ko)

Manual abstract: user guide WHIRLPOOL MFW 1312AGWINSTRUCTION FOR USE

Detailed instructions for use are in the User's Guide.

[. . . ] Before using the washing machine you must remove the transit bolts (see “Installation/ Remove the transit bolts”). 3. Install the washing machine • Install the appliance on a solid and level floor surface. In the case of a yielding sub-floor, the appliance should be installed in the corner of a room. • Adjust the feet to ensure that the machine is stable and level on the floor (see “Installation/ Adjust the feet”). 4. Water inlet • Connect the water supply inlet hose in accordance with the regulations of your local water company (see "Installation/Connect the water inlet hose"). • Water supply: Cold water only • Tap: 3/4” threaded hose connection • Pressure: 100-1000 kPa (1-10 bar). 5 Black process 45. 0° 100. 0 LPI 3gb15063. fm Page 6 Wednesday, October 9, 2002 5:09 PM FIRST WASH CYCLE We recommend that the first wash cycle be made without laundry. [. . . ] Pour in detergent: Chamber • Detergent for the pre-wash Chamber • Detergent for the main wash • Stain remover • Water softener (water hardness 4) When using liquid detergent, put the divider insert in the front slot and in the rear slot when using powder detergent. Chamber • Fabric Softener • Liquid starch Only add fabric softeners and conditioners up to the “Max” mark. Chamber • Liquid chlorine bleach Only add the liquid chlorine bleach up to the “Max” mark. Only use this chamber if the “Bleach” column is shown on the enclosed programme chart. Slide the detergent dispenser in until it clicks shut. Divider insert liquid detergentuse front slot powder detergentuse rear slot Divider insert 9 Black process 45. 0° 100. 0 LPI 3gb15063. fm Page 10 Wednesday, October 9, 2002 5:09 PM Notes: • Keep detergents and additives in a dry place and out of reach of children. • If you use descaling agents, dyes or bleaches, make sure they are suitable for washing machine use. Descaler could contain components that can attack parts of your washing machine. • Do not use solvents (turpentine, benzine, etc. ) Do not machine wash fabrics that have been treated with solvents or flammable liquids. • You can use liquid detergent in the "Prewash" phase for programmes with this option. In this case put only powder detergents in the compartment for the main wash . • When using concentrated fabric softeners, dilute with water in the detergent dispenser up to "MAX" level mark. • To prevent dispensing problems when using highly concentrated powder and liquid detergents, use the special detergent ball or bag supplied with the detergent and place it directly inside the drum. If you use gel-type detergent, please use the powder detergent insert setting. Powder detergent remains in the detergent dispenser until the programme starts, but liquid detergents can run out of the detergent dispenser. Pull the detergent dispenser out until you can see about 3 cm of the chamber. While the water is running into the detergent dispenser, pour the starch solution into the chamber. If there are starch residues in the detergent dispenser after the end of the programme, clean it if necessary (see "Care and Maintenance"). Observe also the starch manufacturer's information. CARE AND MAINTENANCE Appliance exterior and control panel • Clean using normal household cleaner (do not use abrasive products or solvents). • Dry with a soft cloth. Door seal • Clean occasionally with a damp cloth. • Check the seal folds for foreign bodies periodically. 10 Black process 45. 0° 100. 0 LPI 3gb15063. fm Page 11 Wednesday, October 9, 2002 5:09 PM Home Appliances Detergent dispenser 1. Press the release lever in the prewash compartment down and pull out the dispenser. 4. Replace the separate parts in the detergent dispenser and slide the dispenser back into the opening. Periodically check and clean the mesh filters in the water connection. 1. Turn off the tap. 3. Clean the internal filter. 4. Screw the supply hose back onto the tap. [. . . ] Mount the new hose professionally on the washing machine and the tap. Water supply hose “B” If the hose is too short, replace it with a longer length of “Water Stop” hose (available from After-Sales Service or specialist dealer). Note: The inlet hose and the plastic enclosure at the water connection contain electrical components. For this reason, do not cut the hose and do not immerse the plastic enclosure in water. B Connect the water drain hose 1. Connect the drain hose to the ventilated siphon or hook it over the edge of a sink with the “U” bend. 3. Secure the hose so that it cannot fall down while the appliance is running. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL MFW 1312AGW




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL MFW 1312AGW will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.