User manual WHIRLPOOL HB D10 S PROGRAM CHART

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL HB D10 S. We hope that this WHIRLPOOL HB D10 S user guide will be useful to you.


WHIRLPOOL HB D10 S PROGRAM CHART: Download the complete user guide (195 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL HB D10 S PROGRAMKORT (194 ko)
   WHIRLPOOL HB D10 S PROGRAMKORT (194 ko)
   WHIRLPOOL HB D10 S KURZANLEITUNG (198 ko)
   WHIRLPOOL HB D10 S SCHEDA PROGRAMMI (197 ko)
   WHIRLPOOL HB D10 S CUADRO DE MANDOS (200 ko)
   WHIRLPOOL HB D10 S TABLEAU DE PROGRAMMES (200 ko)
   WHIRLPOOL HB D10 S PRODUCT-INFORMATIEBLAD (198 ko)
   WHIRLPOOL HB D10 S KURZANLEITUNG (198 ko)

Manual abstract: user guide WHIRLPOOL HB D10 SPROGRAM CHART

Detailed instructions for use are in the User's Guide.

[. . . ] The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Dispose of in accordance with local standards governing waste disposal. [. . . ] Avoid touching the hob with parts of the body when wet and never use when barefoot. • • • Prolonged use of the hob may alter the colour of the hotplates due to the high temperatures reached. Stainless steel parts must be cleaned with a sponge soaked in soapy water or other suitable non-abrasive products. Acid substances such as lemon juice, tomato, vinegar or similar, make the surface opaque if not removed for a long time. Enamelled parts must be cleaned with a sponge soaked in soapy water or other suitable non-abrasive products. Acid substances such as lemon juice, tomato, vinegar or similar, make the surface opaque if not removed for a long time. ENAMELLED TOPS • • • • • • Type PLATD 230 V - 50 Hz 3, 5 kW 5019 619 01058 To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation. TROUBLESHOOTING GUIDE The hob does not work: - Check for the presence of mains electrical power. - Set the knob to “0” and switch on the hob again to ensure that the fault has been remedied. AFTER-SALES SERVICE Before contacting After-Sales Service: • See if you can solve the problem yourself with the help of the suggestions given in chapter “Troubleshooting Guide”. If after the above checks the fault persists, contact the nearest After-sales Service. Please give: • a brief description of the fault; • the type and exact model of the hob; • the service number (i. e. , the number that follows the word SERVICE on the rating plate, located under the hob). The service number is also indicated on the warranty booklet; • your full address; • your telephone number and area code. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). Failure to comply with these instructions may compromise the safety and quality of the product. Connection to the electrical mains Note: the yellow/green earthing wire (B) must be connected to the screw. 10 mm of sheath from the wires • Open the terminal board (C) by pressing the side tabs by means of a suitable tool. • Insert the power cable (D) in clamp (E) and connect the wires to the terminal board. • After the electrical connection, insert the hob from the above and secure on the fixing brackets as shown in figure 1. Declaration of conformity • This cooking hob is suitable for contact with foodstuffs, and complies with EEC Directive 89/109. • This cooking hob has been designed to be used only for cooking Any other use (such as heating a room) is improper and dangerous • This cooking hob has been designed, constructed and marketed in compliance with: - safety requirements of EEC Directive “Low voltage” 73/23; - protection requirements of EEC Directive “EMC” 89/336; - requirements of EEC Directive 93/68. The hob does not turn off: - disconnect the hob immediately by disconnecting the power cable from the socket. ACCESSORIES: • The glass cover can be ordered via the After Sales Service, with the code: AMC 966 NB (New Black) AMC 966 MR (Mirror) INSTALLATION Recommendations Important: Before any installation or maintenance operation, disconnect the hob from the mains power supply. • Electrical connections must be made before connecting the appliance to the electricity supply. • Installation must be performed by a qualified technician according to the manufacturer's instructions and current local regulations. • After unpacking the hob, check that there has been no damage during transport. [. . . ] If the hob is to be fitted above an oven, the latter must be produced by the same manufacturer and equipped with a cooling system. If the hob is to be installed next to a column unit, leave a distance of at least 100 mm from the edge hob. Fit the seal supplied onto the hob (if not already present), after carefully cleaning the application surface. Fig. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL HB D10 S




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL HB D10 S will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.