User manual WHIRLPOOL AWZ 3203 WP INSTRUCTION FOR USE

[. . . ] • Connect the dryer to an external ventilation system in order to prevent steam from damaging your furniture during the years. 4 Stacking kit Your dryer can be stacked on top of your front loading washing machine. The type of stacking kit is stated in the Instruction for use of your washing machine or pls. [. . . ] Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. 2) For the Republic of Ireland only The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. 3) Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact Whirlpool Service for further instruction. This procedure needs to be carried out by a qualified Whirlpool technician in compliance with the manufactures instructions and current standard safety regulations. 5 PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packing The packing box may be fully recycled as confirmed by the recycling symbol. Energy saving tips Always dry a full load: depending on the type of laundry and the programme/drying time. By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. Place your dryer in a room with a temperature between 15° C and 20° C. Always select the correct programme/drying time for the load in order to obtain the desired drying results. Attach the air vent hose adapter to the connection located under the dryer and lock it by means of the foreseen lugs. Venting outside • Without kinking it, lead the vent hose outside (inside diameter 10 cm, maximum length with two bends 3 m). • Ensure that the vent hose does not sag when stacking the dryer on a washing machine. • Do not connect the air vent hose to a chimney or to a mechanical ventilation extractor duct. Only connect the hose to ventilation systems insulated against humidity. • Please provide adequate ventilation to avoid the back flow of gases into the room from appliances burning other fuels, including open fires. Dryer operation without vent hose • Only use the dryer in a large, well-ventilated room. A minimum distance of 10 cm between rear of appliance and the wall must be observed. Dryer placed close to the wall; venting to the left or right Install the dryer by using the bi-directional kit AMH 869, available at your dealer, should be used. C 8 DOOR REVERSIBILITY Door Reversibility A. Using a spanner, turn the contact pin on the inside of the door (top) through 90° and remove it. C D. [. . . ] Using a spanner, turn the contact pin on the inside of the door (top) through 90° and remove it. C D. Unscrew the 2 screws above and below the door lock system. C D F. Removing the door lock: using a screwdriver, press down on the small rib in the upper opening and extract the door lock by pulling it towards you. [. . . ]