User manual WHIRLPOOL AWO/D 8041 INSTRUCTION FOR USE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL AWO/D 8041. We hope that this WHIRLPOOL AWO/D 8041 user guide will be useful to you.


WHIRLPOOL AWO/D 8041 INSTRUCTION FOR USE: Download the complete user guide (338 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL AWO/D 8041 FICHE PRODUIT (57 ko)
   WHIRLPOOL AWO/D 8041 MODE D'EMPLOI (174 ko)
   WHIRLPOOL AWO/D 8041 GEBRUIKSAANWIJZING (325 ko)
   WHIRLPOOL AWO/D 8041 BEDIENUNGSANLEITUNG (328 ko)
   WHIRLPOOL AWO/D 8041 TABLEAU DE PROGRAMMES (250 ko)
   WHIRLPOOL AWO/D 8041 PRODUCT FICHE (54 ko)
   WHIRLPOOL AWO/D 8041 PROGRAM CHART (273 ko)

Manual abstract: user guide WHIRLPOOL AWO/D 8041INSTRUCTION FOR USE

Detailed instructions for use are in the User's Guide.

[. . . ] 30105900GB. fm Page 1 Tuesday, March 11, 2008 9:44 AM CONTENTS BEFORE USING THE WASHING MACHINE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE DOOR CHILD SAFETY BEFORE THE FIRST WASH CYCLE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES REMOVING THE FILTER/DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE ACCESSORIES TRANSPORT / HANDLING ELECTRICAL CONNECTION 30105900GB. fm Page 2 Tuesday, March 11, 2008 9:44 AM BEFORE USING THE WASHING MACHINE 1. Removing the packaging and inspection • After unpacking, make sure that the washing machine is undamaged. • Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. • If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating. • Use only new hoses to connect the washing machine to the water supply. [. . . ] They depend on: • degree and type of soiling • size of wash full load: follow the detergent manufacturer’s instructions; half load: 3/4 the amount used for a full load; Minimum load (about 1 kg): 1/2 the amount used for a full load • water hardness in your area (ask for information from your water company). Soft water requires less detergent than hard water (refer to the water hardness table in the operating instructions). Notes: Too much detergent can result in excess foam formation, which reduces washing efficiency. If the washing machine detects too much foam, it may prevent spinning. Insufficient detergent may result in grey laundry in time and also calcifies the heating system, drum and hoses. GB 5 30105900GB. fm Page 6 Tuesday, March 11, 2008 9:44 AM Where to put detergent and additives The detergent drawer has three chambers (fig. • If the “Clean filter” indication lights up: IMPORTANT: make sure the water has cooled before draining the appliance. Remove the plinth or open the cover (depending on the model) by using the separator of the detergent dispenser (fig. If your washing machine has the filter situated behind the plinth (see pictures “A” and “C”), use a broad and very flat container with a maximum height of 2 cm. Pour about 1 litre of water into the detergent drawer to reactivate the “Eco system”. Select a programme and start it. B C GB 7 30105900GB. fm Page 8 Tuesday, March 11, 2008 9:44 AM CARE AND MAINTENANCE Appliance exterior and control panel • Can be washed down with a soft, damp cloth. • Dry with a soft cloth. Door seal • Clean with a damp cloth when necessary. • Check the condition of the door seal periodically. Filter • Check and clean the filter regularly, at least two or three times a year (see “Removing The Filter/ Draining Residual Water”). Appliance interior • After each washing, leave the door open for some time to allow the inside of the appliance to dry. • If you never or seldom wash your laundry at 95°C, we recommend to occasionally run a 95°C programme without laundry, adding a small amount of detergent, to keep the interior of the appliance clean. Water supply hose(s) • Check the hose(s) regularly for brittleness and cracks. • Regularly check and clean the mesh filter inside the inlet hose (see “Cleaning the mesh filter in the water supply hose(s)”). Do not use flammable fluids for cleaning the appliance. Detergent dispenser 1. Press the release lever in the main wash compartment downward and remove the dispenser (see light arrow). Remove the separator from the main wash compartment by pulling it upwards (see dark arrows). Refit the separator and the cover grid in the detergent dispenser and fit the dispenser back inside its housing. GB 8 30105900GB. fm Page 9 Tuesday, March 11, 2008 9:44 AM Water supply hose(s) If a supply hose shows a damage, replace it by a new hose of the same type, available through our After-Sales Service or your specialist dealer. “C”), periodically check the colour of the transparent coating. If the coating begins to turn red, this is an indication that the hose may have a leak and should be replaced. Contact our After-Sales Service team or specialist dealer to obtain a replacement hose. A Cleaning the mesh filter in the water supply hose(s) 1. Clean the internal mesh filter and screw the water inlet hose back onto the tap. [. . . ] If failure code “FA” appears on the display: Switch the appliance off, pull out the mains plug and turn the water tap off. Tilt the appliance forward carefully to allow the collected water to flow out from the bottom of the appliance. turn the water tap on (if water immediately flows into the appliance again, without the appliance being started, there is a failure. If the failure occurs again, unplug the appliance and contact our After Sales Service (see “After-Sales Service”). [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL AWO/D 8041




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL AWO/D 8041 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.