User manual WHIRLPOOL AWE 8523 INSTRUCTION FOR USE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL AWE 8523. We hope that this WHIRLPOOL AWE 8523 user guide will be useful to you.


WHIRLPOOL AWE 8523 INSTRUCTION FOR USE: Download the complete user guide (1374 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL AWE 8523 PROGRAM CHART (236 ko)

Manual abstract: user guide WHIRLPOOL AWE 8523INSTRUCTION FOR USE

Detailed instructions for use are in the User's Guide.

[. . . ] 31210328GB. fm Page 1 Wednesday, January 26, 2005 4:42 PM CONTENTS BEFORE USING THE WASHING MACHINE FIRST WASH CYCLE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES PROGRAMME SELECTION CLEANING THE FOREIGN BODY TRAP DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE TRANSPORT AND HANDLING INSTALLATION ELECTRICAL CONNECTION GB 1 31210328GB. fm Page 2 Wednesday, January 26, 2005 4:42 PM BEFORE USING THE WASHING MACHINE 1. Remove the packaging and check a. Remove the bottom protection by tilting and turning the appliance on one rear bottom corner. • After unpacking, make sure that the washing machine is undamaged. • Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children; they are potentially dangerous. 6. Electrical connection • Electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions and the current standard safety regulations. [. . . ] The newly selected programme will start at the washing position where the previous programme was interrupted. Note: Do not add detergent for the new programme. Programme interruption/pause If, for any reason, you want to interrupt the programme for a certain time and continue it later: 1. After the desired pause, press the “Start/Pause” button again. Cancel programme If the current programme has to be terminated prematurely and cancelled, proceed as follows: 1. Press the “Start/Pause” button to start the “Drain” programme. GB 8 31210328GB. fm Page 9 Wednesday, January 26, 2005 4:42 PM CLEANING THE FOREIGN BODY TRAP The appliance is provided with a self-cleaning pump. The foreign body trap keeps objects like buttons, coins, safety-pins etc. Turn the foreign body trap slowly anti-clockwise until the grip is vertical; do not remove it as yet. Make sure the pump impeller (in the housing behind the foreign body trap) is not obstructed. Insert the foreign body trap again and screw it fully down in a clockwise direction to the stop (until the grip is horizontal). Pour 0. 5 litres of water into the machine via the drum and check that water does not leak from the foreign body trap. Check the foreign body trap if the appliance is not draining correctly or if it fails to perform spin cycles. The machine has safety device which stops the washing machine before each filling when water was not removed completely from the tub in previous part of washing programme. Check the foreign body trap regularly, two or three times a year and clean it if necessary. IMPORTANT: Make sure the water has cooled before emptying the foreign body trap. GB 9 31210328GB. fm Page 10 Wednesday, January 26, 2005 4:42 PM DRAINING RESIDUAL WATER When should I drain residual water (draining problem)?• If the appliance is installed in a room subject to sub-zero temperatures. Turn off the tap, disconnect the water supply hose from the machine and allow the water to drain into a basin. Open the foreign body trap, let the water drain into a small shallow basin and close the trap. Release the drain hose then open the fixing clip located at the rear of the machine (see arrow A). Fix the drain hose again with the clip and replace it with the U-bend. Important: • After draining the residual water, screw on the machine’s water supply hose by hand. Check water-tightness of appliance connections by turning the tap completely on. A CARE AND MAINTENANCE Detergent dispenser 1. Replace the dispenser by locating the bottom tabs in the door holes and pivot until both of the upper buttons lock. [. . . ] Carefully screw both water inlet hoses: • hot (see A) fill hose, • and cold (see B) fill hose. The warm water inlet temperature must not exceed 60° C. A B GB 16 31210328GB. fm Page 17 Wednesday, January 26, 2005 4:42 PM Water stop anti-flooding system (depending on model) • Screw the hose to the water supply tap. Turn the tap fully on and check the water-tightness of the connection. • The appliance must not be connected to the mixing tap of a non-pressurized water heater! [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL AWE 8523




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL AWE 8523 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.