User manual WHARFEDALE ATMOS TWIN

[. . . ] - Any repair done by an unauthorized person would cancel the warranty. IMPORTANT Never call for steam when the water tank is empty ; you run the risk of damaging the pump. Never add alcohol-based products (perfumes, eau de cologne, etc) to the water. - Do not point the jet of steam in the direction of any electrical plugs or equipment, including the cleaning appliance itself. [. . . ] Move the locking switch to position 2 = fixed position or position 3 = swivel position. ATTACHING CLOTH TO THE RECTANGULAR BRUSH Press down on end of clamp ; secure cloth under clamp ; release clamp. SETTING OF THE SPECIAL HARD FLOOR CLOTH ON THE RECTANGULAR BRUSH Use both hook-and-loop fasteners to set the cloth around the brush. To obtain steam, the anti-scale cartridge must be inserted into the water tank. Do not use: Rain water, water from the fridge, water from condenser tumble drier, water from any evaporator appliance, water supplied by your water softener if it indicates that the regenerating salts need replacing (incompatibility with the CAPT system). In order to ensure long life to your appliance, and prolong the lifetime of the anti-scale cartridge, we advise you to mix tap and demineralised water. Never add products containing alcohol or essences (perfume, eau de Cologne, lavender essence…) to the water. You do not need to unplug the appliance, and can immediately recommence cleaning. The power on light flashes to indicate that the appliance is connected to the mains. The appliance is ready when the power on light is permanently on and when an audible signal sounds to indicate that the appliance is ready to supply steam. Press the “on/off” button on the pistol handle to ask for steam. PLEASE NOTE Before each use, ask for steam for a few seconds at the maximum steam setting to remove any water condensation which may be located in the main hose. € For smooth surfaces - Cloth should be fixed to the 4 corners: To clean very dirty floors apply the brush directly to the floor without exerting pressure on the bristles : then wipe with the cloth. - Special cloth for wooden floors: For varnished parquet flooring, marble floors and delicate floor surfaces, place the cloth under the brush. € Carpets and Fitted Carpets The cloth should be fixed at the 4 corners for normal care. For dirty or very dirty surfaces the cloth should be fixed at the 2 upper corners. Clean by drawing the brush towards you (the steam loosens the dirt, and the bristles of the brush bring it to the surface). NB : before or after steam cleaning, a vacuum cleaner may be used to collect heavier dust. WINDOW WIPER Steam setting MINI Use the special accessory fitted with the flexible wiper blade. Spray steam over a wide area of glass, and then clean by moving the scraper from top to bottom. It is recommended that you remove accumulated water and dirt before each operation. In cold weather preheat your window by steaming approximately 10 cm away from the glass. [. . . ] - Fill the reservoir - Insert the reservoir and replace the tank cap - Insert an anti-scale cartridge into the reservoir - Insert the anti-scale cartridge correctly and replace the tank cap - Change the anti-scale cartridge. Press the steam button - Go to your local dealer - Fill the reservoir - Insert the reservoir and replace the tank cap - Go to your local dealer - Wait until the indicator light illuminates again before requesting steam. - Press the steam ON/OFF switch: the pilot light goes off and the appliance starts heating again. - Wait until the on/off pilot light is permanently on to use the appliance. [. . . ]