User manual WELLTECH LAN PHONE 101 H.323

[. . . ] All intellectual property rights in this publication are owned by Welltech Computer Co. , Ltd. and are protected by Republic of China copyright laws, other applicable copyright laws and international treaty provisions. No part of this publication may be reproduced in any form whatsoever or used to make any derivative work without prior written approval by Welltech Computer Co. , Ltd. No representation of warranties for fitness for any purpose other than what is specifically mentioned in this guide is made either by Welltech Computer Co. , Ltd. [. . . ] 1. 5 1. Download method There are two methods to download new rom file, please move the "~" symbol by press or on the keypad to select TFTP or FTP method, then press OK to confirm it. Set File Server IP User has to offer one TFTP/FTP server IP Address and set this IP Address on the LAN Phone keypad. The IP Address is necessary for upgrading Lan Phone new application rom file. Set FTP user account User has to press user name and password for FTP server login . It is necessary for upgrading Lan Phone new application rom file in FTP method. Indicate file name User has to press the file name of new application rom file prepared for upgrading Start Download Press OK to start download new application rom file . Note: Download via LCD command can only upgrade new application rom file. 2. 3. 4. Hardware Test LAN Phone 101 supports self-test for the all functions buttons. Reboot (mandatory) It is necessary and important for user to reboot it after any configurations has been made to the LAN Phone 101. 17 Copyright (c) 2002 WellTech Computer Corporation LAN Phone Ver 109 Release 2002/06/07 LAN Phone 101 User Manual Guide Document Ver. 1. 5 Chapter 3 Advanced Configurations via Telnet After initializing the LAN Phone 101 IP Address setting (please refer to LCD Configuration: 1. Connect Configuration), user can enter into configuration mode via telnet. Note: 1. After user enter LAN Phone configuration via telnet, please use login:"root", password:"press enter" to enter command line. 2. Each command user must key-in with lower case, but contents of configurations such as h. 323 alias or user name etc, user can set as capital case. 3. User who changes any configuration needs to do the commit command then reboot command. 1. The following figure is shown all commands of LAN Phone 101. 18 Copyright (c) 2002 WellTech Computer Corporation LAN Phone Ver 109 Release 2002/06/07 LAN Phone 101 User Manual Guide Document Ver. [quit] command Type quit/exit/close will logout LAN Phone 101 and Program ­Telnet. 3. [reboot] command After doing commit command, type reboot to restart the LAN Phone 101. 4. [flash] command This command will clean the configuration stored in the flash rom to default value and reboot the LAN Phone 101. Note: After user upgrade new software version , suggested to execute this command to make sure new software work well on LAN Phone 101. Note: To execute the command flash ­clean, all configuration of LAN Phone 101 stored on flash rom will be cleaned. It is authorized for the user whose login name is "root" only. 5. [commit] command Save any changes after configuring the LAN Phone 101. 19 Copyright (c) 2002 WellTech Computer Corporation LAN Phone Ver 109 Release 2002/06/07 LAN Phone 101 User Manual Guide Document Ver. [ifaddr] command Configure and display the LAN Phone 101 IP information. -ip, -mask, -gate: Set LAN Phone 101 IP Address, subnet mask and default gateway respectively. [. . . ] If a user login with "administrator", two commands are not functional: 1. passwd ­clean: clean up password restored before, and user can login :"root/adminstrator", password:"press enter". flash ­clean:only "root" users can clean all configurations stored in flash. rom ­boot :only "root" users can upgrade LAN Phone boot rom version. [. . . ]