User manual WEEMOTE WEEMOTE 2 QUICK GUIDE

[. . . ] Fobis Technologies Inc. "designing gadgets for real life" Mute PWR INTRODUCTION This installation guide is designed to get your weemote® 2 setup as quickly as possible. In order to ensure a fast setup, please follow this guide, step-by-step, in the order presented. The companion "REFERENCE GUIDE" provides more detail for those who need more information, have complex entertainment systems or wish to further customize the Weemote's setup. It also contains the TV and Set-Top codes needed to configure your Weemote®. [. . . ] If all these functions work, then you have the right code for your TV. If any of the functions above do not work, then you will need to try another TV code. NOTE: When you are finished testing and you are using a Set-Top box with your system, then you will need to set the TV back to the correct channel or video input (see Step 12). 1. Turn on your Cable Box , Satellite Receiver or Personal Video Recorder. Please note that TiVo and Replay (PVR) units are considered Set-Top devices to the weemote®. If you also have a Set-Top box with these units, you only need to program in the TiVo or Replay code as your STB setting. 2. Please refer to the CABLE, SATELLITE OR PERSONAL VIDEO RECORDER CODES listed in the Reference Guide. If you cannot find your brand listed there, then please refer to the Reference Guide to search for your code. Locate the first code for your brand Set-Top device. STEP 9 LAST STEP FOR TV ONLY USERS! 4. Press and hold the "STB" button for about three seconds until the LED light begins to flash. Press the "1" button 3 times = 3 In this example, there is no need to use the "100" and "10" buttons as the channel number is below 10. The LED should flash three times and then turn off to confirm that the code was entered. 1. Write the TV code down on the battery sticker located behind the battery door. If you are also using a Set-Top box, then you will need to proceed directly to STEP 10. Go to www. weemote. com 12 STEP 10 CONTINUED STEP 12 TEST THE SET-TOP CODE 8. Press the RED power button to see if the SetTop box turns off (*See Note Below). If it does not, then go back to the beginning of Step 10, using the next code number listed for your manufacturer. If you have run through all the possible codes and still cannot get the Set-Top box to power off, then please refer to the Reference Guide on how to search for your code. * Some codes may operate channel changing but not power. If you leave your Set-Top normally on, then you can use one of these codes. In this case, for each code tested, try to see if you can change channels by pressing the channel up/down button (long blue button) By using one of these codes, the weemote® will not power the Set-Top box on/off. IMPORTANT NOTE: If your Set-Top box is set to use Channel 2, 4, 5 on your TV or your TV is cabled using direct video connections (RCA Jacks or S-Video), then please go to Page 16 to set the Channels/Direct Video option, then come back to this Step. Point the Weemote® at your Set-Top box and press the Power (red) button. Now, check the volume up/down button as well as the channel up/down button. If all these functions work, then you have the right code for your SetTop box. [. . . ] This is normal since the weemote® is designed to limit channel access. Sometimes, the programmed channels get knocked out of alignment when the child is pressing the buttons too quickly?The first is to check and make sure whether you need the ENTER or 3-Digit option. Some TV's and Set-Tops will delay until they change channels if they do not see 3-Digits or an ENTER command. [. . . ]