User manual VTECH VT 9109

[. . . ] INTRODUCTION ANY KEY ANSWER 40 CHANNEL OPERATION 9109 UNIQUE STAND UP DESIGN USER'S MANUAL Parts Check List: 1. Battery Pack HANDSET BASE UNIT MHz VTECH TELECOMMUNICATIONS LTD. com Printed in China TELEPHONE LINE CORD BATTERY PACK AC ADAPTER 1 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Do not use this product near water (for example, near a bath tub, kitchen sink, or swimming pool). [. . . ] To make sure your phone rings when the handset is away from the base, please keep the base antenna in the upright position. To answer a call when the handset is away from the base, just press any key on the handset (except OFF). This is very useful in a dark environment; you do not have to fumble around looking for the PHONE key to answer the call. OPERATING INSTRUCTIONS Disconnecting To end a call, either place the handset back in the base, or press OFF on the handset. Changing Channels If you notice interference when using your handset, press CHAN to switch to a clear channel. Temporary Tone If you have a rotary (dial-pulse) telephone service, (TONE/PULSE switch is set to PULSE), this feature allows you to enter special codes and tones to operate answering machines, use electronic banking services, calling cards, or other special services. You can then press the numbers or symbols you need, and your phone will send the proper signals. Turning ON/OFF The Ringer Set the ringer switch on the handset to ON or OFF. Memory Dialing The VT 9109 can store up to 10 different phone numbers that you can dial just by pressing phone, MEM/PROG and one of the number keys (0-9). The PHONE LED will blink to indicate that you are in the programming mode. Press the number of the memory location you wish to store the number in (0-9). The phone now exits MEM/PROG mode and you will hear a long confirmation beep. For example, to dial the number you assigned to key '8', you would press PHONE, MEM/PROG, 8. * If you recently installed a new battery pack, make sure it is installed correctly. * Make sure the telephone line cord is plugged firmly into the base unit and the telephone jack. * You may have too many extension phones on your telephone line to allow all of them to ring. * Replace the handset in the base cradle, wait a few moments and try again. * Disconnect your base unit from the telephone jack, and plug in a regular telephone. If you still hear other calls, the problem is probably in your wiring or local service. * Your base unit and handset may not be operating on the same channel or security code. Place the handset in the cradle for a few moments to reload the security code and reset the channel. COMMON CURE FOR ELECTRONIC EQUIPMENT Electronics, like people, can sometimes get confused. If the unit does not seem to be responding normally, then try putting the handset in the cradle to re-initialize the unit. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures: * Reorient or relocate the receiving antenna. [. . . ]