User manual VTECH LS6225-5

[. . . ] c o m Models: LS6225/LS6225-2/ LS6225-3/LS6225-4/ LS6225-5/LS6226-2 Congratulations on purchasing your new VTech product. Before using this telephone, please read the Important safety instructions on page 45 of this manual. This manual has all the feature operations and troubleshooting necessary to install and operate your new VTech telephone. Please review this manual thoroughly to ensure proper installation and operation of this innovative and feature rich VTech product. [. . . ] New answering system messages. ANS ON NEW MUTE 1/3 New call log entries. Message number currently playing and total number of messages recorded. 34 Appendix Battery It takes up to 16 hours for the battery to be fully charged. When it is fully charged, you can expect the following performance: Operation While in handset use (talking*) While in speakerphone mode (talking*) While not in use (standby**) Operating time Up to eight hours Up to five hours Up to six days *Operating times vary depending on your actual use and the age of the battery. The battery needs charging when: · · · · A new battery is installed in the handset. LOW BATTERY or PLACE IN CHARGER shows on the handset screen. CAUTION: To reduce the risk of fire or injury, read and follow these instructions: · Use only the battery(ies) provided or equivalent. To order a replacement, visit our website at www. vtechphones. com or call 1 (800) 595-9511. Check with local waste management codes for special disposal instructions. Released electrolyte is corrosive and might cause burns or injury to the eyes or skin. · Exercise care in handling batteries in order not to create a short circuit with conductive materials. · Charge the battery(ies) provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual. · Observe proper polarity orientation between the battery and metallic contacts. · To prevent fire or shock hazard, do not expose this product to water or any type of moisture. 35 Appendix Expand your telephone system The handsets provided with your telephone system are pre-registered. Additional handsets registered to the telephone system are assigned in sequential order. For instance, if the telephone system already has HANDSET 1 and HANDSET 2, the new registered handset is assigned HANDSET 3. This telephone system accommodates up to 12 handsets. Add and register a handset (optional) You can add new handsets (LS6205, purchased separately) to your telephone system, but each handset must be registered with the telephone base before use. You may need to charge the handset before registering to the telephone base. If PRESS FIND HS 4 SEC ON BASE does not appear on the handset screen after a few seconds, remove the handset and place it in the telephone base or charger again. On the telephone base, press and hold FIND HANDSET for about four seconds (until the red IN USE light on the telephone base turns on) and then release the button. The handset shows HANDSET X REGISTERED (X represents the handset number assigned) and you hear a beep when the registration completes. · If the registration fails, the handset shows NOT REGISTERED. To reset the handset, remove the handset from the telephone base and place it back in. · You cannot register a handset if any other system handset is in use. 36 Appendix Replace a handset If you want to replace a handset or re-assign the designated handset number of a registered handset, you must de-register all the handsets and then individually register each handset. [. . . ] In most, but not all areas, the sum of all RENs should be five (5. 0) or less. If you have specially wired alarm dialing equipment connected to your telephone line, ensure the connection of this equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone service provider or a qualified installer. If this equipment is malfunctioning, it must be unplugged from the modular jack until the problem has been corrected. [. . . ]