User manual VTECH LS6115-2

[. . . ] User's manual www. vtechphones. com Models: LS6115-2 on purchasing your new VTech product. Before using this telephone, please read the Important safety instructions on page 38 of this manual. This manual has all the feature operations and troubleshooting necessary to install and operate your new VTech telephone. Please review this manual thoroughly to ensure proper installation and operation of this innovative and feature rich VTech product. For support, shopping, and everything new at VTech, visit our website at www. vtechphones. com. [. . . ] If the product has been dropped and the telephone base and/or handset has been damaged. Avoid using a telephone (other than cordless) during an electrical storm. Do not use the telephone to report a gas leak in the vicinity of the leak. Only put the handset of your telephone next to your ear when it is in normal talk mode. The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling or an under-the-table/cabinet outlet. SAVE THESE INSTRUCTIONS 38 www. vtechphones. com Troubleshooting If you have difficulty with your telephone, please try the suggestions below. For Customer Service, visit our website at www. vtechphones. com, or call 1 (800) 595-9511; in Canada, call 1 (800) 267-7377. Problem My telephone does not work at all. Suggestion · Make sure the battery is installed and charged correctly (page 3). For optimum daily performance, return the handset to the telephone base or charger after use. · Make sure the power adapter is securely plugged into an outlet not controlled by a wall switch. · Make sure the telephone line cord is plugged firmly into the telephone base and the telephone wall jack. Allow up to one minute for the cordless handset and telephone base to synchronize. If that still does not work, it may be necessary to purchase a new battery. · Disconnect the telephone base from the telephone wall jack and plug in a working telephone. If the other telephone does not work, the problem is probably in the wiring or the local service. Call the local telephone company. L O W B AT T E RY i s · Place the handset in the telephone base or charger for recharging. · Remove and re-install the battery and use it normally until fully discharged, then recharge the handset on the telephone base or charger for up to 16 hours. · If the above measures do not correct the problem, the battery may need to be replaced. Appendix www. vtechphones. com 39 Troubleshooting Problem The battery does not charge in the handset or the handset battery does not accept charge. Suggestion · Make sure the handset is placed in the telephone base or charger correctly. · Remove and reinstall the battery, then charge for up to 16 hours. · If the handset is in the charger or in the telephone base but the CHARGE light on the handset is not on, refer to The CHARGE light is off in this section. Please refer to the Battery section (page 37) of this user's manual. · Clean the charging contacts on the handset(s) and telephone base each month using a pencil eraser or a dry non-abrasive fabric. [. . . ] If you have specially wired alarm dialing equipment connected to your telephone line, ensure the connection of this equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer. If this equipment is malfunctioning, it must be unplugged from the modular jack until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents. [. . . ]