User manual VTECH I6720 INSTALLATION GUIDE

[. . . ] Connect power to handset charger Register a handset · Quick installation guide i6720 Choose the location for your handset charger, and plug charger adapter into an electrical outlet not controlled by a wall switch. Parts checklist: · · Check to make sure the phone's package includes the following: 1. Quick installation guide When the handset shows NOT REGISTERED, place the handset on a base unit or charger that is connected to a power outlet. [. . . ] at 1 (800) 267-7377. To attach To remove Install handset battery 1. Align the two holes in the plug with the socketpins, matching the red and the black connectors, then snap plug into place. Place the battery in the compartment with the wires in the upper right corner. Neatly tuck the wires next to the battery inside the battery compartment. eplace cover by sliding it upwards until it clicks into place. Registration T6720u, uv-ister all your handsets, then register the new handset and re-register all the old handsets one at a time. After a while the handset will emit series of tones, the newly registered handset will be assigned the lowest extension number not previously assigned to another system handset when successfully registered. epeat the steps in Register a handset if the new handset does not successfully register to the base unit within two minutes. Note: · If the de-register process does not work, you may need to reset the system and try again. Then, press the OFF button and place the handset back into the base unit. · ucucuvu W before registering to base unit. De-register all handsets · · · Press and hold FIND HANDSET on the base unit for four seconds, the IN USE light will light up. Keep pressing FIND HANDSET for another six seconds until the IN USE fl, then release the FIND HANDSET button. The IN USE light will turn off and in a few seconds, all handsets will be de-registered. [. . . ] eleased electrolyte is corrosive and may cause damage to the eyes or skin. · Exercise care in handling batteries in order not to create a short circuit with conducting materials such as rings, bracelets, and keys. [. . . ]