User manual VTECH GRIP N GO DRIVER

[. . . ] When it comes to providing electronic learning products that enlighten, entertain and develop minds, at VTECH® we see the potential in every child. 1 INTRODUCTION Thank you for purchasing the VTECH® Grip `n Go DriverTM learning toy!We at VTECH® are committed to providing the best possible products to entertain and educate your child. Should you have any questions or concerns, please call our Consumer Services Department at 1-800-5212010 in the U. S. The VTECH® Grip `n Go DriverTM is a fun electronic steering wheel for toddlers 6 months and up. [. . . ] To adjust the volume, slide the VOLUME CONTROL SWITCH located on the back of the unit to ( or ( ) for LOW VOLUME ) for HIGH VOLUME. 3. Slide the ON/OFF/MODE SELECTOR SWITCH to the OFF ( ) position to turn the unit OFF. 5 4. To remove the attachment strap, hold onto the attachment strap and gently pull on the steering wheel. To re-attach it, push both pieced together until they lock. ® Grip 'n Go DriverTM Note: To preserve battery life, the VTECH® Grip `n Go DriverTM learning toy will automatically power down after about ten seconds without input. The unit can be turned on again by pressing any button. ACTIVITIES A. Slide the ON/OFF/MODE SELECTOR SWITCH to the TALKING MODE ( ) position. All the lights will flash randomly with the sound. "Let's go" + short tune 2. Press the FIRE ENGINE BUTTON to hear "fire engine" followed by a siren sound effect. The corresponding light will flash with the voice and sound effect. "Fire engine" + siren sound effect 6 3. Press the AMBULANCE BUTTON to hear "ambulance" followed by a siren sound effect. The corresponding light will flash with the voice and sound effect. "Ambulance" + siren sound effect 4. Press the POLICE CAR BUTTON to hear "police car" followed by a siren sound effect. The corresponding light will flash with the voice and sound effect. "Police car" + siren sound effect 5. The corresponding light will flash with the sound effect. VTECH Printed in China 91-01446-000 Random horn sound effect ® Grip 'n Go DriverTM 7 6. All the lights will flash randomly with the melody. ® Grip 'n Go DriverTM B. Slide the ON/OFF/MODE SELECTOR SWITCH to the MELODY MODE ( ) position. All the lights will flash randomly with the sound. "Let's go" + short tune 2. Press the FIRE ENGINE BUTTON to hear "square" followed by one random melody. The corresponding light will flash with the voice and all the lights will flash with the music. "Square" + melody 8 3. Press the AMBULANCE BUTTON to hear "circle" followed by one random melody. [. . . ] We make every effort to ensure the accuracy of the information, which forms the value of our products. It is important for you to know that we stand behind our products and encourage you to call our Consumer Services Department at 1-800-521-2010 in the U. S. , or 1-800-267-7377 in Canada, with any problems and/or suggestions that you might have. Note: This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, it may cause interference to radio and television reception. It has been type tested and found to comply within the limits for a Class B computing device in accordance with the specifications in Sub-part J of Part 15 FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. [. . . ]