User manual VTECH CS5121-4

[. . . ] User's manual www. vtechphones. com Models: CS5121-2/CS5121-3 CS5122-3/CS5121-4 on purchasing your new VTech product. Before using this telephone, please read the Important safety instructions on page 47 of this manual. This manual has all the feature operations and troubleshooting necessary to install and operate your new VTech telephone. Please review this manual thoroughly to ensure proper installation and operation of this innovative and feature rich VTech product. For support, shopping, and everything new at VTech, visit our website at www. vtechphones. com. [. . . ] When the system answers and announces the greeting, enter the two-digit security code. If you have new messages, the system will play them (new messages first) automatically. You may also enter one of the following remote commands. Command 1 2 3 33 4 5 *5 6 *7 8 0 Play all messages. Function · If you pause more than four seconds after each remote command completed, the system will announce the help menu options. If no remote command is entered within 15 seconds, the remote access call will be automatically disconnected. · When the answering system is turned off, the telephone will answer after 10 rings, and announce "Please enter your remote access code. " Basic operation Answering system 4. Hang up or press 8 to end the call. www. vtechphones. com 43 Handset display screen messages Displays: LOW BATTERY CID EMPTY CONNECTING. . . DIRECTORY EMPTY LINE IN USE MEMORY FULL XX MISSED CALLS **PAGING** PARALLEL SET ON PHONE POWER FAILURE OR OUT OF RANGE **RINGING** When: The battery needs to be recharged. There is no power connected to the telephone base or the handset is too far away from the telephone base. There is an incoming call. 44 www. vtechphones. com Handset display screen messages Displays: RINGER OFF SCANNING. . . Another system handset is in use. Appendix www. vtechphones. com 45 Battery After the battery is fully charged for 16 hours, you can expect the following performance: Operation While in use (talking) While not in use (standby*) *Handset is off the telephone base but not in use. Operating time Five hours Six days The battery needs charging when: · A new battery is installed in the handset. · LOW BATTERY is displayed and the battery indicator on the handset screen is flashing. CAUTION: To reduce the risk of fire or injury to persons, read and follow these instructions: · Use only the battery(ies) provided or equivalent. To order a replacement, visit our website at www. vtechphones. com or call 1 (800) 595-9511. Check with local waste management codes for special disposal instructions. Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. · Exercise care in handling batteries in order not to create a short circuit with conductive materials such as rings, bracelets, and keys. · Charge the battery(ies) provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO WATER OR ANY TYPE OF MOISTURE. 46 www. vtechphones. com Important safety instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including the following: 1. Do not use this product near water (for example, near a bathtub, kitchen sink, or swimming pool). Do not place this product on an unstable table, shelf, stand or other unstable surfaces. Slots and openings in the back or bottom of the telephone base and handset are provided for ventilation. [. . . ] The telephone company is required to notify you before interrupting service. If advance notice is not practical, you will be notified as soon as possible. You will be given the opportunity to correct the problem and the telephone company is required to inform you of your right to file a complaint with the FCC. Your telephone company may make changes in its facilities, equipment, operation, or procedures that could affect the proper functioning of this product. [. . . ]